Digital Dual-Input Doherty Configuration for Ultrawideband Application.

Weimin Shi,Songbai He,Jun Peng,Jinchen Wang

DOI: https://doi.org/10.1109/tie.2019.2944095

IF: 7.7

2020-01-01

IEEE Transactions on Industrial Electronics

Abstract:In this article, based on a dual-input configuration (DIC), a method for implementing ultrawideband or multiband load-modulated Doherty power amplifiers (DPAs) is proposed. The proposed DIC possesses two Doherty operating modes with respect to the working frequency. Each subamplifier of the DIC plays a changeable role versus frequency, changing from carrier to peaking or changing from peaking to carrier. A dual-input DPA working over 0.7-3 GHz (a relative bandwidth of 124%) is constructed for validating the proposed theory. Under continuous-wave signal excitation, experimental results illustrate that the fabricated power amplifier achieves a 6-dB back-off efficiency of over 40% across 0.7-3 GHz. The maximum output power of the fabricated DPA changes from 42.2 to 44.7 dBm across the whole working band. Meanwhile, a 20-MHz wideband modulated signal with a peak-to-average ratio of 6.04 dB is utilized to stimulate the fabricated DPA at 0.9, 1.8, 2.4, and 2.8 GHz. After digital predistortion, the measured adjacent channel leakage ratios are less than $-$50 dBc at four experimental frequency points.