Abstract:The virtual fields method (VFM) is a novel highly efficient non-iterative tool for the identification of the constitutive parameters of materials. The VFM can obtain several constitutive parameters based on the full-field deformation of the specimen measured in a single test. However, the available results demonstrate that the accuracy of the identification result is strongly dependent on the quality of the deformation field, which is generally measured using optical methods. Especially, in the case where a small deformation is applied under elastic loading, the image noise and measurement error will exhibit a significant influence on the identification results. By combining the VFM with moiré interferometry (MI), a MI-based VFM is used to identify the parameters of an orthotropic linear elastic material. A numerical experiment is conducted to examine the feasibility of this method. From the analysis results, we determine that two factors exhibit an influence on the identification accuracy. The reinforcement direction of the orthotropic material is one factor, and the other is the noise in the deformation field. This MI-based VFM is then applied to determine the mechanical parameters of a unidirectional carbon fiber composite material. In the measurement, a three-point bending load is applied to the specimens. A high density grating with a frequency of 1200line/mm grating is replicated on the specimen surface and used for measuring the in-plane deformation fields using a moiré interferometer. The obtained deformation fields are taken as the inputs of the VFM identification process, and the elastic properties of the materials are identified. The obtained results verify the advantage of the proposed method with respect to high accuracy and good noise immunity.

Orientation-Identified Virtual Fields Method Combined with Moiré Interferometry for Mechanical Characterization of Single Crystal Ni-based Superalloys

Effect of Alloying Elements on Lattice Misfit and Elasticities of Ni-based Single Crystal Superalloys by First-Principle Calculations

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

Identification of Thermomechanical Parameters Based on the Virtual Fields Method Combined with the Sampling Moiré Method

Virtual fields method coupled with moiré interferometry: Special considerations and application

Multi-parameter Identification of the Single Edge Notched Tensile Specimen Using the Virtual Fields Method

Application of Moiré Interferometry to the Characterization of Orthotropic Materials in the Antisymmetric Configuration Using the Virtual Fields Method

Characterization of Material Mechanical Properties Using Strain Correlation Method Combined with Virtual Fields Method

A XRD Method to Measure Orientation of Single Crystal Superalloys

Physically based modelling of orientation deviation effect on mechanical behavior for dual‐phase single‐crystal superalloy

Inertia-based identification of elastic anisotropic properties for materials undergoing dynamic loadings using the virtual fields method and heterogeneous impact tests

Numerical and Experimental Studies on the Heterogeneous Mechanical Characteristics of the Laser Repaired Components

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Stress Concentration Induced by the Crystal Orientation in the Transient-Liquid-Phase Bonded Joint of Single-Crystalline Ni3Al

Orientation dependence of microstructure deformation mechanism and tensile mechanical properties of Nickel-based single crystal superalloys: A molecular dynamics simulation

High temperature in-situ SEM observation and crystal plasticity simulation on fretting fatigue of Ni-based single crystal superalloys

The effect of crystal orientation on fretting fatigue crack formation in Ni-based single-crystal superalloys: In-situ SEM observation and crystal plasticity finite element simulation

First-Principles Calculations for the Elastic Properties of Ni-Base Model Superalloys: Ni/Ni3al Multilayers

Study on Fracture Behavior of Nickel-Based Single Crystal Superalloy Subjected to High Temperature Fatigue Using Digital Image Correlation

Orientation and temperature dependence of yielding and deformation behavior of a nickel-base single crystal superalloy

In-situ fatigue behavior study of a nickel-based single-crystal superalloy with different orientations