Abstract:Over-the-air (OTA) radiated testing for multiple-input multiple-output (MIMO) capable mobile terminals has been actively discussed in the standardization in recent years, where multi-probe anechoic chamber (MPAC) method has been selected, together with the radiated two-stage method. The supported test zone size is a key parameter to determine for an MPAC design, and the test zone size is restricted by the number of OTA antennas. A larger test zone would necessitate more OTA antennas, each port of which is driven by an expensive channel emulator radio frequency interface. Results available in the literature are typically limited to free space scenarios, where no user effect in the vicinity of MIMO terminal is present. There is a concern whether or not the test zone size should encompass the user phantom, together with the mobile terminal in the MPAC setup. To address this issue, an extensive measurement campaign was carried out in this paper. Two realistic long term evolution mockups were designed and their performance were evaluated under standard spatial channel models with and without the presence of user phantom. The measurement results have shown that the nearby user phantom can significantly affect the MIMO performance. However, its impact on the test zone size of the MPAC system is negligible, since emulation accuracy in terms of received power, branch power ratio, antenna correlation, and measured throughput under the target and the emulated channels is not affected by the presence of user phantom. Moreover, results measured with the synthetic MPAC method generally match those obtained with the reference two-stage method. These findings are valuable inputs for the ongoing MIMO OTA harmonization work in the standardization.

Comparisons of Channel Emulation Methods for State-of-the-Art Multi-Probe Anechoic Chamber Based Millimeter-Wave Over-the-Air Testing

Accuracies of Channel Emulation Methods for Sectored Multi-probe Anechoic Chamber

Accuracy Comparisons of Channel Emulation Methods for Two-dimensional Uniform and Three-dimensional Sectored Multi-probe Anechoic Chamber

Impact of Probe Coupling on Emulation Accuracy in Massive MIMO OTA Testing

Over-the-Air Testing of 5G Millimeter-Wave System with Adaptive Beamforming

A Non-Kronecker Structured PFS Method for Channel Emulation in Multiprobe OTA Setups

Experimental Evaluation of User Influence on Test Zone Size in Multi-Probe Anechoic Chamber Setups

Improvement on Doppler Reconstruction in Multiprobe OTA Setups for Directional-Antenna Devices

A Low-Cost and Efficient Single Probe Based MIMO OTA Measurement Method

A Review of Over-the-Air Testing Methods for Performance Measurement of Antennas and Devices in Communication Systems

Over-the-Air Radiated Testing of Millimeter-Wave Beam-Steerable Devices in a Cost-Effective Measurement Setup.

Correcting Deviations of Emulated Spatial Correlation for Prefaded Signal Synthesis Method With Limited Number of Random Drops in MIMO OTA Testing

Test Zone Validation for FR2 MPAC Using Directional Antenna Based Virtual Array

Key issues and algorithms of multiple-input-multiple-output over-the-air testing in the multi-probe anechoic chamber setup

Robustness Analyses of 3D Probe Configuration for Different Channel Models in MIMO OTA Setups

A Realisation of Channel Emulation in a Reverberation Chamber method for Over-the-Air Compliance Testing in Support of 3GPP Standardisation

Cross Evaluation of Multiple Access Schemes Using Post-Experimental Field Data for Underwater Acoustic Communications

28 GHz mmWave Channel Measurements: A Comparison of Horn and Phased Array Antennas and Coverage Enhancement Using Passive and Active Repeaters

An Overview of Probe-Based Millimeter-Wave/Terahertz Far-Field Antenna Measurement Setups [measurements Corner]

A Framework for Developing and Evaluating Algorithms for Estimating Multipath Propagation Parameters from Channel Sounder Measurements

Signal Emulation and Charater Research of Millimeter Wave Passive Detection