Abstract:There exist only a few published papers on fatigue crack overload retardation of poly(methyl methacrylate) (PMMA)[2-4], which is frequently used as windshield transparent material in aircraft industry. In this paper we study the overload retardation in MDYB-3, a Chinese PMMA material for aircraft windshield; while difference in material is of some interest, our main purpose is to gain a somewhat deeper understanding of overload retardation. We present an experimental investigation of fatigue crack retardation behavior-caused by intermediate single peak tensile overloads-of MDYB-3 PMMA plate under constant amplitude cyclic loading. This kind of PMMA was biaxially pre-tensioned during manufacturing procedure. Computerized tomography (CT) specimens were used in fatigue test. The overload ratio γ is defined as the ratio of peak value of overload cycle Pmax,OL, to that of baseline fatigue cycles Pmax. Six ratios of overloads were used, ranging from 1.0 to 2.15. To acquire sufficient measuring data, each specimen was overloaded two or three times for different crack lengths. It could be seen that, for the tested overload ratios, there was an instant crack extension during overloading for γ≥ 1.5. As soon as the overload cycle was removed, instant delay in crack growth occurred. The shut off ratio of overload γSO, corresponding to growth rate of 10-7 mm/cyc at stress ratio R=0, was determined to be 2. 18 via data processing of aforementioned testing. Ostensibly, the fatigue crack response of MDYB-3 material subjected to overloading is similar to that of commonly used metallic materials. But a close watch on the crack surface morphology of PMMA specimens revealed the unique behavior of crack growth during and after single-peak overloading. Following overloading, severe blunting and irregularity occurred at crack frontings, which prevented the cracks from continuing to extend until new fatigue cracks were reinitiated from both ends of the blunted crack frontings and propagated forward and inward.

Multi-crack Propagation in PMMA Plates under Dynamic Out-of-plane Impact

Experimental study of dynamic fracture behavior of PMMA with overlapping offset-parallel cracks

Dynamic Fracture Process During Three-Point- Bending Impact on Polymethyl-Methacrylate Beams

Dynamic optical visualization on the interaction between propagating crack and stationary crack

Dynamic fracture testing of polymethyl-methacrylate (PMMA) single-edge notched beam

Experimental Investigation of Dynamic Fracture Behaviors of Polymethyl Methacrylate

Dynamic Fracture Behavior of Single and Contacting Poly(methyl Methacrylate) Particles

Fatigue Crack Propagation in Polyethylene Methacrylate

Study of the defect-crack offset distance on the impact fracture behavior of plexiglass

Numerical study on crack propagation under explosive loads

Experimental studies on dynamic fracture behavior of thin plates with parallel single edge cracks

Dynamic initiation and propagation behaviour of sub-interfacial cracks in PMMA/aluminium bi-material system

Study of the effect of lengths on the propagation mechanism of interconnected cracks under impact loads

Study the effect of circular hole on dynamic fracture properties of cracked PMMA specimen under impact loads

Craze Density Based Fatigue-Damage Analysis in Polyethylene Methacrylate

Experimental Study of Fatigue Crack Overload Retardation in PMMA

Connecting modes of two cracks under impact loads

Experimental Study on Crazing Initiation and Damage in PMMA under Creep

Fractal damage and crack propagation of PMMA in multiple slit charge blasting

Distribution and Propagation of Matrix Cracks Within Composite Laminates under Impact

Mixed-Mode Fracture Investigation of Pmma with Initial Single/Double Crack(S) Interference Using Phase-Shifted Coherent Gradient Sensing Method