Abstract:This research aims to measure the material parameters and porosity of the resin matrix composite material produced by hot moulding process under various pressures. The laser ultrasonic technique has been used as the measurement technique and the guided wave dispersion relationship was obtained in the resin matrix. In the resin substrate, the single-layer flat plate Lamb wave model was applied to inversely calculate the material parameters and compared with tensile test and traditional ultrasonic measurements. In the woven composite laminate, the specimens were produced with different porosity using the hot pressing moulding process, scanned with computed tomography to confirm the porosity under different pressure and the dispersion curve changes were observed using the laser ultrasonic technique. Result showed that the inversely calculated thickness of pure resin test pieces were consistent with the laser ultrasonic measurement within an error of 5%. The elastic modulus of inverse calculation and the actual tensile test values showed within 12% of error. In the woven fibre composite, the dispersion curve obtained by the laser ultrasonic measurement showed that, as the porosity increases, the dispersion curve tends to shift to a lower wave velocity. In addition to that, the porosity of the woven composite is not changed under different hot pressing pressures. The computed tomography scanning indicated that the pores are mostly concentrated in the overlap of the carbon fibre weaving and extended along the fibre warp and weft directions, showing cross-shaped pores.

Variation of Voids and Inter-Layer Shear Strength of Advanced Polymer-Matrix Composites at Different Pressures with High-Pressure Microwave

Effect of Cure Pressure on Microstructure and Interlaminar Shear Strength Properties of Carbon Fiber–reinforced Plastics with Microwave Curing

Study on the heating mechanism and macro/micro properties of composite materials under microwave curing

Optimization of a high-pressure microwave curing process for T800/X850 carbon fiber-reinforced plastic

Experimental Characterization of Porosity and Interlaminar Shear Strength in Polymeric Matrix Composites

Improvement of the Compressive Strength of Carbon Fiber/Epoxy Composites Via Microwave Curing

Effect of Microwave Curing Process on the Flexural Strength and Interlaminar Shear Strength of Carbon Fiber/bismaleimide Composites

Effect of curing pressure on voids and mechanical properties of carbon fiber reinforced composite laminates

Effect of Vibration Pretreatment–Microwave Curing Process Parameters on the Mechanical Performance of Resin-Based Composites

Numerical Optimizing and Experimental Evaluation of Stepwise Rapid High-Pressure Microwave Curing Carbon Fiber/epoxy Composite Repair Patch

Microwave Curing of Carbon Fiber/Bismaleimide Composite Laminates: Material Characterization and Hot Pressing Pretreatment

A Novel Method for Curing Carbon Fiber Reinforced Plastics by High-Pressure Microwave

A unique method for curing composite materials by introducing vibration treatment into the hybrid heating process

Experimental investigation of vibration pretreatment-microwave curing process for carbon fiber reinforced resin matrix composites

The Optimization of Thermo-Compression Process Parameters of Continuous Carbon Fiber Reinforced PEEK Composites

Effects of cure cycles on void content and mechanical properties of composite laminates

Effects of Cure Pressure Induced Voids on the Mechanical Strength of Carbon/Epoxy Laminates

Effect of Voids and Crystallinity on the Interlaminar Shear Strength of In-Situ Manufactured CF/PEEK Laminates Using Repass Treatment

Microwave curing technology and its application in polymers

Study on Curing Pressure and Mechanical Behaviours of Glass/unsaturated Polyester Composite

Study on Porosity and Material Parameters of Hot Moulded Resin Matrix Composites using Nondestructive Laser Ultrasound Technique