Abstract:The new power system with increasingly high renewable energy proportion necessitates the combined heating and power (CHP) generation units to provide more flexibility. With full consideration of operation characteristics, this paper firstly proposes an advanced coal-fired CHP-CAES system consisting of a 350 MW coal-fired CHP unit and a 30 MW CAES system, which realizes more efficient energy utilization and enhances the system adjusting flexibility through thermal cycles integration and energy comprehensive utilization. The thermodynamic models and multi-dimensional performance analysis models are separately established. Based on that, the comparative study is conducted for two CHP-CAES configurations and the stand-alone CHP unit. With 80% heating load, the minimum power ratio is lowered by 11.69% rated power and the maximum power output is increased by 6.35% rated power, and 27.26 tons of coal can be saved for a single cycle compared with the stand-alone CHP unit. The results also demonstrate that the system still has superiority when the load ratio changes. Techno-economic evaluations for a typical application scene show that the dynamic payback period of the proposed system is shortened by 10.41 years compared with the reference separate CHP-CAES system. These results show that the proposed system presents better performance in energy utilization, enhancing flexibility, realizing clean and low-carbon heating as well as techno-economics. In addition, parametric analysis is implemented to find the influence of CAES parameters on the system. It is found that increasing the expander inlet temperature and air storage pressure can further enhance the system round-trip performance. Yet, the investment cost increases greatly for higher storage pressure and the payback period will be lengthened. Furthermore, the system advantages are strengthened with a CAES system of greater capacity. Nevertheless, we find that the deep coupling in the thermodynamic cycle of the two systems results in an upper capacity for the integrated CAES system, and it is nearly 35 MW for the studied system. These regularities and conclusions can provide theoretical guides and directions for the customized CAES system design with the purpose to integrate with a coal-fired CHP unit.

Improvement of Fuel Sources and Energy Products Flexibility in Coal Power Plants Via Energy-Cyber-physical-systems Approach

A Study on Operation Control of Urban Centralized Heating System Based on Cyber-Physical Systems

Two-timescale Nonlinear Model Predictive Control for Flexible Operation of Coal-Fired Power Plant with Post Combustion CO2 2 Capture System

An Electricity-Carbon Joint Market Optimization Model for Coal-Fired Power System under China's “Dual-Carbon” Target

Collaborative Optimization for a Multi-Energy System Considering Carbon Capture System and Power to Gas Technology

Thermodynamics, flexibility and techno-economics assessment of a novel integration of coal-fired combined heating and power generation unit and compressed air energy storage

A Perspective on the Applications of Energy-Cyber-physical Systems (E-Cpss) in Ultra-Low Emission Coal-Fired Power Plants

Flexibility Enhancement of Combined Heat and Power Unit Integrated with Source and Grid-Side Thermal Energy Storage

Coordination of Maintenance and Multi-Technical Flexibility Retrofits for Coal-Fired Power Plants

Energy Storage Improves Power Plant Flexibility and Economic Performance

Operational Flexibility and Thermodynamic Performances of a Combined Heat and Power Plant Integrated with Carbon Capture System

Techno-economic analysis of coal staged conversion polygeneration system for power and chemicals production

CCUS-assisted electricity-chemical polygeneration system for decarburizing coal-fired power plant: Process integration and performance assessment

Flexibility and Efficiency Co-Enhancement of Thermal Power Plant by Control Strategy Improvement Considering Time Varying and Detailed Boiler Heat Storage Characteristics

Assessing the Synergies of Flexibly-Operated Carbon Capture Power Plants with Variable Renewable Energy in Large-Scale Power Systems

A Stochastic MPC-Based Flexibility Scheduling Strategy for Community Integrated Energy System Considering Multi-Temporal-Spatial-Scale and Inertia Components

Study of Dynamic Response Characteristics of S-CO2 Cycle in Coal-Fired Power Plants Based on Real-Time Micro-Grid Load and a Novel Synergistic Control Method with Variable Working Conditions

Performance Analysis of Coal-Fired Power Plants Integrated with Carbon Capture System under Load-Cycling Operation Conditions

Dynamic Performance Enhancement of Solar-Aided Coal-Fired Power Plant by Control Strategy Optimization with Solar/Coal-to-Power Conversion Characteristics

Dynamic flexibility optimization of integrated energy system based on two-timescale model predictive control

Enhancing the Integration of PV and Coal-Fired Power Plant for Low-Carbon, Low-Cost, and Reliable Power Supply Through Various Energy Storage Systems