Abstract:Centrifugal compressor is one of the key components in the Super-critical carbon dioxide (SCO2) Brayton cycle process, its performance prediction under variable operating conditions are concerned a lot with consideration of the unique of SCO2 properties. At the same time, the general techniques, including numerical simulation, test, and theoretical analysis with the loss models, are applied to evaluate the compressor performance. In addition with numerical analysis on the performance of the compressor, the flow loss models from air compressor were studied and extended the application to the SCO2 compressors, including incidence loss, blade loading loss, passage flow loss, tip clearance loss, mixing loss, disk friction loss, vaneless diffuser loss. All of these models were investigated to get the performance of a SCO2 compressor. The CO2 quality was got from the multipurpose NIST REFPROP 9.0 (NiST) which is based on Span and Wagner equation of state. The quality was added in the numerical simulation process. Besides, the passage flow loss factor has been modified to get more accurate theoretical performance prediction method for SCO2 compressor. The predicted performance map was compared to the numerical results, and the comparison results proved that, the combination of the loss models provided the similar results as those from the numerical simulation. For the SCO2 centrifugal compressor, the passage flow loss covers the most part among all the compressor flow losses. The value of the passage flow loss factor applied in the theoretical performance prediction method ranges between 0.008∼0.025, which is higher than that for air. Finally, the performance evaluation by improved loss models at different compression starting points were compared with that by the numerical results, it was found that, closer to the critical point would make the passage flow loss increase a lot, which may even exceed its rational range and the produced loss would be beyond expectation. This might be the reason for the low efficiency of SCO2 compressor in the practical working conditions.

A Method to Select Loss Correlations for Centrifugal Compressor Performance Prediction

Multi-Objective Optimization Method for Performance Prediction Loss Model of Centrifugal Compressors

Optimum loss models for performance prediction of supercritical CO2 centrifugal compressor

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Loss prediction of axial compressors using genetic algorithm-back propagation neural network in throughflow method

Quantitative analysis of energy loss and performance prediction of regenerative compressor

Performance Evaluation for Sco2 Compressor with Loss Models Consideration

Accuracy and Sensitivity Analysis of Aerodynamic Performance Prediction Models for Transonic Axial-Flow Compressors

An axisymmetric characteristic model for enhancing the prediction of centrifugal compressor characteristics

Performance Prediction of Transonic Axial Compressors Using Improved Streamline Curvature Approach

A blade design performance based off-design loss prediction method for axial flow compressors and cascades

An Improved Streamline Curvature Method for Centrifugal Compressor Performance

The Study of Performance Forecast for Centrifugal Compressors

Performance prediction method of low specific speed centrifugal and vortex refrigerant pump

Reduced-dimensional Prediction Method for the Axial Aerodynamic Forces in the Off-Design Operation of Near-Critical CO2 Centrifugal Compressors

Numerical Method of Transonic Axial Compressor Performance Prediction

Quantitative Study on Equivalent Roughness Conversion Coefficient and Roughness Effect of Centrifugal Compressor

Methods for Gas Turbine’s Compressor General Characteristic Curve Prediction

An Improved Streamline Curvature Approach for Transonic Axial Compressor Performance Prediction

Power-loss methodology for a compressor cascade at various Reynolds numbers and its validation

Numerical Investigation of Low Reynolds Number Effects on Energy Loss inside Centrifugal Compressor with Different Inlet Conditions