Abstract:Powder coatings are gaining popularity for their economic and environmental benefits. Additives (pigments) such as zinc phosphate enhance the anti-corrosive properties of coatings, but their behavior in powder coatings has not been extensively studied. In this study, zinc phosphate was incorporated into three powder coating systems: polyester clearcoat, polyester and epoxy coatings with filler BaSO4. Neutral salt spray and electrochemical tests (OCP, LPR, and EIS) confirmed that the anti-corrosive performance improved with the addition of zinc phosphate. The optimal additive dosage was determined to be 2% for all of the coating systems studied here, based on salt spray tests. Here, the time until failure increased by 1.5 to 2 times. Using electrochemical tests, an optimal additive dosage of 8% was found for the polyester clearcoat, while the other coating systems maintained an optimal additive dosage of 2%. Performance increased by as much as one order of magnitude based on resistance/impedance measurements. This suggested a synergistic effect between the additive and the filler. The passivation layer was confirmed by both X-ray diffraction and Raman spectroscopy. Based on the results and discussion presented in this article, the discrepancy was caused by different features of the two tests, such that the electrochemical tests probe the function of intact coatings, whereas salt spray measures only the corrosion spreading from the scribe. It is proposed that the two test methods characterize different aspects of the coatings, corresponding to their service conditions. This has theoretical and practical significance in the evaluation of anti-corrosive coatings. Other properties of the coatings, including adhesion, gloss, distinctness-of-image, and pencil hardness, were measured as per applicable standards and the conformance was verified.

A comparative study of nanoscale poly N-(vinyl) pyrrole in polyvinyl butyral coatings for the anti-corrosion property of zinc: Nanotubes vs nanoparticles

High Performance Anti-Corrosion Coatings of Poly (vinyl Butyral) Composites with Poly N-(vinyl)pyrrole and Carbon Black Nanoparticles.

Effect of Nano-SnS and Nano-MoS2 on the Corrosion Protection Performance of the Polyvinylbutyral and Zinc-Rich Polyvinylbutyral Coatings

Effect of Polypyrrole Nanostructures on the Anti-Corrosion Performance of Polypyrrole/polyvinyl Butyral/carbon Black Coatings

High anticorrosion performance of polyvinyl butyral/carbonized polyaniline/modified titanium dioxide composite coating

Comparative study on anti-corrosion behavior of granular polypyrrole and polypyrrole nanotube in waterborne epoxy coatings

Corrosion Behavior of 304 L Steel Coated with PVB/PAn-Nano Metal Oxide (TiO2, ZnO)

Nanocomposites of Polybenzoxazine-Functionalized Multiwalled Carbon Nanotubes and Polybenzoxazine for Anticorrosion Application

Novel Conducting Polymer Based Composite Coatings for Corrosion Protection of Zinc

Wrinkled p-phenylenediamine grafted graphene oxide as reinforcement for polyvinyl butyral anti-corrosive coating

Comparative Study of Carbonaceous and Polymer Conductive Additives on Anticorrosion Performance of Epoxy Zinc-Rich Primer

Study on the Formation of Poly (2-Vinylpyridine) Coatings Electropolymerized on Zinc-Electroplated Steel and Its Corrosion Behavior

Tribological and Anticorrosion Performance of Electroplated Zinc Based Nanocomposite Coatings

Studies on coatings containing nano‐zinc oxide for steel protection

Corrosion protection of PPy-Ti3C2-modifed epoxy zinc-rich coatings in dilute NaCl solution

Impact of calcium zirconate nanoparticles on the mechanical and anti-corrosion properties of Ni-P coatings

Property Studies of Polypyrrole/zno Nanocomposites by Electrochemical Polymerization

Preparation and anti‐corrosion performance of nano Polyaniline/Polyurethane interpenetrating network composite coating

Corrosion resistance of MWCNTs-nanoZnO composite reinforced chromium-free Zn-Al coating

Comparative Study of Corrosion Properties of Different Graphene Nanoplate/Epoxy Composite Coatings for Enhanced Surface Barrier Protection

A Comparative Study on the Anti-Corrosive Performance of Zinc Phosphate in Powder Coatings