Effect of the Vertical /slanted Staggered Barrier on Autostereoscopic Displays

Chen Yu,Zhao Yan,Zeng Xiang-yao,Yao Jian-min,Ye Yun,Lin Zhi-xian,Chen En-guo
DOI: https://doi.org/10.3788/yjyxs20193407.0659
2019-01-01
Chinese Journal of Liquid Crystals and Displays
Abstract:Autostereoscopic three-dimensional (3D) displays realized by traditional parallax barriers exists the limitations of serious crosstalk, obvious Moire fringe, narrow visual area and the lopsided loss of light in the horizontal and vertical directions. In this paper, the effects of the parameters of the parallax barrier on the Moire fringe, crosstalk, and visible area are studied, including the tilt angle of the slit grating, the slit width, and the slit offset distance. The design detail of the proposed staggered barrier is analyzed. Two kinds of parallax barrier devices are optimized, which adopt a vertical staggered barrier and a slanted staggered barrier, respectively. Based on 4 viewpoints slanted staggered barrier, the adjacent slits are divided into sub sections at the half point of pixel height. Experimental results show that the vertical staggered barrier and slanted staggered barrier are effective in reducing the Moire fringe with the staggered distance of 0.053 7 mm and 0.030 2 mm respectively when the inclination angle theta is 12.2 degrees It is proved that the slanted staggered barrier can increase the visual area by 17.9% higher than that of vertical staggered barrier at the cost of increasing the crosstalk by 1.57%. Moreover, the light energy loss in the horizontal and vertical directions can match more effectively, which demonstrates that slanted staggered barrier improves the 3D visual effect for the autostereoscopic displays.
What problem does this paper attempt to address?