Abstract:Detecting oil slick covered seawater surface using the thermal infrared remote sensing technology exists the advantages such as: oil spill detection with thermal infrared spectrum can be performed in the nighttime which is superior to visible spectrum, the thermal infrared spectrum is superior to detect the radiation characteristics of both the oil slick and the seawater compared to the mid-wavelength infrared spectrum and which have great potential to detect the oil slick thickness. And the emissivity is the ratio of the radiation of an object at a given temperature in normal range of the temperature (260-320 K) and the blackbody radiation under the same temperature , the emissivity of an object is unrelated to the temperature, but only is dependent with the wavelength and material properties. Using the seawater taken from Bohai Bay and crude oil taken from Gudao oil production plant of Shengli Oilfield in Dongying city of Shandong Province, an experiment was designed to study the characteristics and mechanism of thermal infrared emissivity spectrum of artificial crude oil slick covered seawater surface with its thickness. During the experiment, crude oil was continuously dropped into the seawater to generate artificial oil slick with different thicknesses. By adding each drop of crude oil, we measured the reflectivity of the oil slick in the thermal infrared spectrum with the Fourier transform infrared spectrometer (102F) and then calculated its thermal infrared emissivity. The results show that the thermal infrared emissivity of oil slick changes significantly with its thickness when oil slick is relatively thin (20-120 μm), which provides an effective means for detecting the existence of offshore thin oil slick In the spectrum ranges from 8 to 10 μm and from 13. 2 to 14 μm, there is a steady emissivity difference between the seawater and thin oil slick with thickness of 20 μm. The emissivity of oil slick changes marginally with oil slick thickness and clearly below that of seawater in the spectrum range from 11. 7 to 14 μm, this spectrum range can be practically used to distinguish oil slick from seawater; Around the wavelength of 11.72, 12.2, 12.55, 13.48 and 13.8 μm, the emissivity of oil slick presents clearly increasing or decreasing trends with the increase of its thickness, which are one of the best wavelengths for observing the offshore oil slick and estimating its thickness.

Terahertz EM Backscattering from Sea Surface Covered by Oil Film with Finite Thickness at Small Incident Angle

Investigation on THz EM Wave Scattering From Oil-Covered Sea Surface: Exploration for an Approach to Probe the Thickness of Oil Film

Theoretical Study on Microwave Scattering Mechanisms of Sea Surfaces Covered With and Without Oil Film for Incidence Angle Smaller Than 30°

Thermal Infrared Emissivity Spectrum and Its Characteristics of Crude Oil Slick Covered Seawater

Spectral Response Analysis of Offshore Thin Oil Slicks

The Remote Sensing Inversion Theory of Offshore Oil Slick Thickness Based on A Two-Beam Interference Model

An Optical Remote Sensing Model for Estimating Oil Slick Thickness Based on Two-Beam Interference Theory

Scattering Model-Based Oil-Slick-Related Parameters Estimation From Radar Remote Sensing: Feasibility and Simulation Results

Electromagnetic Scattering Characteristics of Pec Targets in the Terahertz Regime

Modeling of EM Scattering by Composite Surfaces Made of Wake Due to a Submerged Body and Wind-Driven Sea Waves

Acoustic Scattering From Rough Bubbly Ocean Surface Based on SSA and EMM

[Experimental Study of Offshore Oil Thickness Hyperspectral Inversion Based on Bio-Optical Model].

Experimental Study on Spectral Responses of Offshore Oil Slick

Refinement of the Critical Angle Calculation for the Contrast Reversal of Oil Slicks under Sunglint

Model-based comparisons of near-coincident TerraSAR-X and COSMO-SkyMed VV-polarized SAR measurements over sea surface with and without oil slicks

An alternative approach to determine critical angle of contrast reversal and surface roughness of oil slicks under sunglint.

Combined Retrieval of Oil Film Thickness Using Hyperspectral and Thermal Infrared Remote Sensing

Quantifying Ocean Surface Oil Thickness Using Thermal Remote Sensing

Oil film identification via windspeed interference estimation using hyperspectral data

Simultaneous Estimation of the Refractive Index and Thickness of Marine Oil Slick from the Degree of Linear Polarization of the Sun-Glint Reflection

The Extended Bragg Scattering Model-Based Method for Ship and Oil-Spill Observation Using Compact Polarimetric SAR