Abstract:We present a Kalman filter-based approach for estimating external forces and torques relying on a dynamic model of a serial-chain robotic manipulator where only motor signals (currents, joint angles, and joint speeds) are measurable. The method does not require any additional sensing compared to standard robot control systems. The approach exploits redundancy in 7DOF arms, but also applies to traditional 6DOF manipulators. Automatic filter calibration routines are presented minimizing the number of parameters that must be tuned in order to successfully apply the proposed scheme and to optimize estimation quality. The approach is verified by measurement data gathered from an ABB YuMi, a dual-arm collaborative robot with 7DOF each arm. Furthermore, measurement results are presented employing force and torque estimates in a compliance control scheme, verifying that the estimation quality achieved is improved compared to existing approaches and is sufficient to employ the estimates in force-controlled applications.Note to Practitioners—More and more robotic applications involve contact with at least partially unknown environments. As a consequence, they require control approaches that go beyond the traditional position control. In particular, information about contact forces and torques has to be taken into account. However, integrating additional sensing equipment to obtain the required force/torque information is often technically challenging and expensive. Cartesian contact force and torque estimation allows obtaining force/torque information solely from available sensors. The estimation technique can be regarded as a virtual sensor, and hence this brief deals with a key technology enabling force controlled robotic applications such as assembly, grinding, and deburring without the need for expensive additional sensing.

Multi-Point Interaction Force Estimation For Robot Manipulators With Flexible Joints Using Joint Torque Sensors

Contact Force Estimation for Robot Manipulator Using Semiparametric Model and Disturbance Kalman Filter.

Torque Limitation Control of Industrial Manipulators Based on General Weighted Least Norm Method

Force Estimation and Motion Control of Hydraulic Manipulators Based on Extended State Observer

Joint Torque and Ground Reaction Force Estimation for a One-Legged Hopping Robot.

Variable Impedance Force Tracking with a Collaborative Joint Based on Second-Order Momentum Observer Under Uncertain Environment

Multi-Momentum Observer Contact Estimation for Bipedal Robots

Proprioceptive Sensor-Based Simultaneous Multi-Contact Point Localization and Force Identification for Robotic Arms

Terminal Force Soft Sensing of Hydraulic Manipulator Based on the Parameter Identification

Unified Motion/Force/Impedance Control for Manipulators in Unknown Contact Environments Based on Robust Model-Reaching Approach

Motor-Current-Based Estimation of Cartesian Contact Forces and Torques for Robotic Manipulators and Its Application to Force Control

An evaluation approach for motion-force interaction performance of parallel manipulators with closed-loop passive limbs

End-Effector Force and Joint Torque Estimation of a 7-DoF Robotic Manipulator Using Deep Learning

Sensorless force estimation of end-effect upper limb rehabilitation robot system with friction compensation

Contact Force Estimation Using Uncertain Torque Model and Friction Models for Robot Manipulator

A regularized approach for frictional impact dynamics of flexible multi-link manipulator arms considering the dynamic stiffening effect

An Input Observer-Based Stiffness Estimation Approach for Flexible Robot Joints

Multi-Contact Whole-Body Force Control for Position-Controlled Robots

Model-free Friction Observers for Flexible Joint Robots with Torque Measurements

Force-free Control for the Flexible-Joint Robot in Human-Robot Interaction

Unified Force and Motion Adaptive-Integral Control of Flexible Robot Manipulators