Abstract:Background. Accurate timing offset calibration is crucial for time-of-flight (TOF) positron emission tomography (PET) to mitigate image artifacts and improve quantitative accuracy. However, existing methods are often time-consuming, complex, or costly.Objective. This paper presents a method for TOF PET timing offset calibration that eliminates the need for costly equipment, phantoms, short-half-life sources, and precise source positioning.Approach. We estimate channel timing offsets using stationary scans of a68Ge line source, typically used for routine quality control, at a minimum of three non-coplanar positions, with each position scanned for two minutes. The line source positions are accurately determined by applying a simple algorithm to their reconstructed images, allowing precise calculation of arrival time differences. Channel timing offsets are estimated by solving a least squares problem. This method is assessed through analyses of phantoms and patient images using a RAYSOLUTION DigitMI 930 scanner.Main results. The estimated timing offsets ranged from -500 ps to 500 ps across all channels. Calibration with a minimum of three scanned positions was sufficient to correct these offsets, achieving less than a 1% discrepancy across various metrics of the image quality (IQ) phantom compared to 12 positions. This calibration significantly reduced edge artifacts in TOF reconstruction of both phantoms and patients. Furthermore, the IQ phantom displayed a 14% increase in average contrast recovery, a 61% reduction in average background variability across all spheres, and a 90% reduction in average residual error. Consistent with the phantom results, patient data revealed enhancements in maximum standardized uptake values (SUVmax) from 14% to 55% for lesions measuring 6 mm to 14 mm. The calibration also improved lesion-to-background contrast and eliminated artifacts caused by the spillover effect of the kidneys and bladder.Significance. The proposed method is fast, user-friendly, and cost-effective, effectively improving lesion detection and diagnostic accuracy.

Timing Calibration for PET Based on Low Rank Constraint

PET timing calibration using low rank constraint

Deep Learning Based Timing Calibration for PET

Sub-Detector Unit Timing Calibration for Brain Pet Based on L1-Norm Constraint

Timing Optimization with Position Information for TransPET

Nonlocal Total Variation Based Dynamic PET Image Reconstruction with Low-Rank Constraints

An Efﬁcient LiDAR-IMU Calibration Method Based on Continuous-Time Trajectory

Enhancing Coincidence Time Resolution of PET Detectors Using Short-Time Fourier Transform and Residual Neural Network

Timing offset calibration for TOF PET using stationary line source scans at multiple positions

Sparse/Low Rank Constrained Reconstruction for Dynamic PET Imaging.

Simultaneous Reconstruction and Segmentation of Dynamic Pet Via Low-Rank and Sparse Matrix Decomposition

Dynamic Low-Count PET Image Reconstruction Using Spatio-Temporal Primal Dual Network.

Nonlocal Low-Rank and Total Variation Constrained PET Image Reconstruction

3D Tensor Based Nonlocal Low Rank Approximation in Dynamic PET Reconstruction.

Simultaneous Reconstruction and Segmentation for Dynamic PET: A Low Rank Framework.

Novel Crystal Timing Calibration Method Based on Total Variation

Pet Image Resolution Uniformity Improvements Using Deep Learning

A Deep ADMM-net for Iterative Low-Count PET Reconstruction

Joint Reconstruction of Dynamic PET Activity and Kinetic Parametric Images Using Total Variation Constrained Dictionary Sparse Coding

Robust Framework for PET Image Reconstruction Incorporating System and Measurement Uncertainties.

Timing Estimation Algorithm Incorporating Spatial Position for Monolithic PET Detector