Abstract:Controlling the rotating detonation combustor (RDC) is crucial for enhancing propulsion system safety, efficiency, and overall performance. Swift and precise identification of the operational mode of RDC is of great significance for refining the propulsion dynamics of detonation-based technologies. In this study, two-dimensional numerical simulations are performed to investigate time-domain characteristics and frequency-domain characteristics of various operational modes of the RDC, hydrogen-air mixtures are used as fuel, and fast Fourier transformation (FFT) is applied to the analysis of frequency-domain. The alteration of the RDC operational mode is achieved through adjustments to the chemical equivalent ratio (ER) of the fuel, spanning from 0.52 to 3.50. Our findings reveal four distinct operational modes within this equivalent ratio range: ignition failure (ER <= 0.52 and ER >= 3.50), collision failure (ER = 0.85, 1.60 and 1.65), single wave (0.53 <= ER <= 0.80 and 1.70 <= ER <= 3.40) and multiple wave mode (0.90 <= ER <= 1.50). For the ignition failure mode, the detonation waves in RDC decouple from the flame and fail after ignition. In the collision failure mode, the inability of detonation waves to propagate sustainably within the RDC is evident. Frequency-domain analysis underscores the significance of a characteristic low-frequency (0.3 kHz) in distinguishing this mode from others. For single wave mode, it represents the steady and continuous propagation of a detonation wave in the RDC. Frequency-domain analysis reveals characteristic frequencies approximately equal to integer multiples of the propagation frequency (f(D)), where f(D) similar to 10f(D) serves as the primary characteristic frequencies. The multiple wave mode can be categorized into two subtypes: the forward and reverse single detonation waves appear alternately or the forward and reverse single detonation waves finally co-direction double detonation waves. In the former subtype, characteristic frequencies are integer multiples of the f(D), but the amplitude distribution is different with single wave mode. In contrast, primary characteristic frequencies of the latter subtype are f(D) similar to 4f(D), accompanied by two adjacent characteristic frequencies near each integer multiples of f(D). These findings promise advancements in the controllability of RDC and lay the foundations for the development of RDC control systems.

Performance analysis of dual-duct rotating detonation aero-turbine engine

Comprehensive Performance Analysis of the Turbofan with a Multi-Annular Rotating Detonation Duct Burner

Comprehensive Performance Analysis for the Rotating Detonation-Based Turboshaft Engine

Thermodynamic performance analysis of the rotating detonative airbreathing combined cycle engine

Over-all performance analysis of a dual-entry turbocharger compressor with variable geometry orifice

Analysis of Coupling Supersonic Turbine Stage with Rotating Detonation Combustor under Different Turbine Parameters

Analysis of Energy Saving and Thrust Characteristics of Rotating Detonation Turbine Engine

Investigation of the Pressure Gain Characteristics and Cycle Performance in Gas Turbines Based on Interstage Bleeding Rotating Detonation Combustion

Analysis of Operating Diagram for H2/Air Rotating Detonation Combustors under Lean Fuel Condition

Influence of propagation direction on operation performance of rotating detonation combustor with turbine guide vane

Experimental study on the suppression of inlet blockage in rotating detonation combustor by porous-wall

On the Challenges of Integrating a Rotating Detonation Combustor With an Industrial Gas Turbine and Important Design Considerations for Row-1 Blades

Numerical study on the integration of supersonic turbine guide vanes and three-dimensional hydrogen/air rotating detonation combustor

Large-eddy Simulation Study of Rotating Detonation Supersonic Turbine Nozzle Generated by the Method of Characteristics under Oscillating Incoming Flow

On the wave propagation modes and operation range in rotating detonation combustor with varied injection and outlet throat

Flow-field Analysis and Pressure Gain Estimation of a Rotating Detonation Engine with Banded Distribution of Reactants

Experimental Investigation of Thermal Prediction and Heat Transfer Characteristics of Two-Phase RDE during Long-Duration Operation

Performance analysis of pulse detonation ramjet

Experimental investigation on the performance of the variable cross section rotating detonation engine

Time/frequency Domain Analysis of Detonation Wave Propagation Mechanism in a Linear Rotating Detonation Combustor

Analysis on Propulsive Performance of Hollow Rotating Detonation Engine with Laval Nozzle