Abstract:The stack is a crucial component of the thermoacoustic heat engine, influencing its capacity to generate stable pressure amplitude and enhance efficiency. Utilizing the discontinuous Galerkin (DG) method, fully compressible Navier-Stokes equations were solved to simulate the energy exchange between the stack and surrounding air under various conditions. (1) Simulations were conducted under different stack wall boundary conditions, including linear temperature distribution wall, isothermal wall, and adiabatic wall. The work performed by 1 kg of gas at a specific position during one cycle was defined as local energy density to analyze the effect of different stack spacing, stack length and stack thickness. (2) Too small a stack spacing causes the inability to generate pressure amplitude. Increasing the stack spacing continuously enhances the generated pressure amplitude, with the energy density distribution near the hot heat exchanger becoming more significant. As the stack spacing continues to increase, the energy density decreases at positions farther from the wall, leading to a reduction in pressure amplitude. The generated acoustic streaming intensity diminishes faster with the continuous increase in stack spacing. (3) A smaller stack length results in reduced viscous dissipation at the wall, leading to a larger generated pressure amplitude. However, shorter stack lengths cause increased gas oscillation displacement, resulting in lower energy density concentrate around the stack. This raises the load on the two heat exchangers, consequently reducing the overall efficiency. (4) The pressure amplitude decreases with the increase in stack thickness. The vortex intensity at the gap between the hot heat exchanger and the stack increases with the stack thickness, leading to higher viscous losses for the fluid passing through this region. Consequently, the performance of the thermoacoustic engine declines. These findings provide valuable guidance for the design of thermoacoustic engines.

Comprehensive Performance Improvement of Standing Wave Thermoacoustic Engine with Converging Stack: Thermodynamic Analysis and Optimization

Study on the Performance of a Looped Thermoacoustic Prime Mover With Resistance Tube

Theoretical and Experimental Investigation of Acoustic Field Adjustment of a Gas-Liquid Standing-Wave Thermoacoustic Engine

Study on a Looped 2-Stage Thermoacoustic Engine

Influence of Gedeon Streaming on Performance of Four-Stage Travelling-Wave Thermoacoustic Engine

Performance of a Looped Thermoacoustic Engine with Multiple Loads Capable of Utilizing Heat Source below 200 °C

Basic Analysis on a Thermoacoustic Engine with Gas and Liquid

Influence of load impedance on performance of thermoacoustic engine

Performance comparison of thermoacoustic engines with constant-diameter resonant tube and tapered resonant tube

Experimental Study On A Thermoacoustic Engine With Brass Screen Stack Matrix

Performance Comparison of Looped Thermoacoustic Electric Generators with Various Thermoacoustic Stages

Numerical Simulation Investigating the Influence of Varied Stack Parameters on the Energy Conversion in Thermoacoustic Engines

Investigation on the influence of working pressure on the performance of the thermoacoustically driven RC load

Numerical Simulation of Nonlinear Phenomena in a Standing-Wave Thermoacoustic Engine with Gas-Liquid Coupling Oscillation

Effect of Resonance Tube Shape on Performance of Thermoacoustic Engine

Thermoacoustically Driven Pulse Tube Cooler below 60K

Performance of an Air‐cooled Looped Thermoacoustic Engine Capable of Recovering Low‐grade Thermal Energy

The Performance Optimization of a Standing-Wave Thermo-Acoustic Engine

Full-scale numerical simulations of standing-wave thermoacoustic engines with circular-pore and pin-array stacks

Numerical Analysis on Thermoacoustic Prime Mover

Simulation of A Standing-Wave Thermoacoustic Engine Using Compressible Simple Algorithm