Abstract:Honeycomb structures have found numerous applications as structural and biomedical materials due to their favourable properties such as low weight, high stiffness, and porosity. Application of additive manufacturing and 3D printing techniques allows for manufacturing of honeycombs with arbitrary shape and wall thickness, opening the way for optimizing the mechanical and physical properties for specific applications. In this study, the mechanical properties of honeycomb structures with a new geometry, called octagonal honeycomb, were investigated using analytical, numerical, and experimental approaches. An additive manufacturing technique, namely fused deposition modelling, was used to fabricate the honeycomb from polylactic acid (PLA). The honeycombs structures were then mechanically tested under compression and the mechanical properties of the structures were determined. In addition, the Euler-Bernoulli and Timoshenko beam theories were used for deriving analytical relationships for elastic modulus, yield stress, Poisson's ratio, and buckling stress of this new design of honeycomb structures. Finite element models were also created to analyse the mechanical behaviour of the honeycombs computationally. The analytical solutions obtained using Timoshenko beam theory were close to computational results in terms of elastic modulus, Poisson's ratio and yield stress, especially for relative densities smaller than 25%. The analytical solutions based on the Timoshenko analytical solution and the computational results were in good agreement with experimental observations. Finally, the elastic properties of the proposed honeycomb structure were compared to those of other honeycomb structures such as square, triangular, hexagonal, mixed, diamond, and Kagome. The octagonal honeycomb showed yield stress and elastic modulus values very close to those of regular hexagonal honeycombs and lower than the other considered honeycombs.

Study on Mechanical Properties of Honeycomb Pentamode Structures Fabricated by Laser Additive Manufacturing: Numerical Simulation and Experimental Verification

Effects of Structural Parameters on the Poisson's Ratio and Compressive Modulus of 2D Pentamode Structures Fabricated by Selective Laser Melting

Numerical and Experimental Investigation of Static Four-point Bending Response of Honeycomb Sandwich Structure: Failure Modes and the Effect of Structural Parameters

In-plane Compression Behavior of Hybrid Honeycomb Metastructures: Theoretical and Experimental Studies

Topological design of pentamode metamaterials with additive manufacturing

Ultrahigh Compression-Shear Ratio of Sandwich Pentamode Metamaterials

Mechanical properties of additively manufactured octagonal honeycombs

Massive and Fast Fabrication of Pentamode Devices Through a Multiphase Honeycomb-Corrugation Configuration

Additive Manufacturing of Honeycomb Lattice Structure—From Theoretical Models to Polymer and Metal Products

Mechanical Response of Triply Periodic Minimal Surface Structures Manufactured by Selective Laser Melting with Composite Materials

Local Strengthening Design and Compressive Behavior Study of the Triangular Honeycomb Structure

Optimization Design, Mechanical Properties, and Energy Absorption Characteristics of Thin‐Walled Porous Structures Manufactured by Selective Laser Melting

Modelling and characterization of novel honeycomb structures with mass gradient produced by additive manufacturing

Mechanical Properties of Multi-Materials Porous Structures Based on Triply Periodic Minimal Surface Fabricated by Additive Manufacturing

Research on shape memory alloy honeycomb structures fabricated by selective laser melting additive manufacturing

Optimization of printing parameters and out-of-plane compression performance of 316L stainless steel ribbed honeycomb

Fabrication and mechanical properties of three- dimensional enhanced TiAl/GH3536 hetero- honeycomb sandwich structure

EQUIVALENT MECHANICAL PROPERTIES OF ADDITIVELY MANUFACTURED OCTAGONAL HONEYCOMBS: THEORETICAL AND EXPERIMENTAL ANALYSIS

Bamboo-inspired, simulation-guided design and 3D printing of light-weight and high-strength mechanical metamaterials

Evaluation of the influence of design in the mechanical properties of honeycomb cores used in composite panels

Microstructure and Mechanical Properties of TC4/TA2 Honeycomb Structure Fabricated by Selective Laser Melting(SLM)