Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Design, Synthesis and Photoelectrical Properties of Diphenylamine-Containing Triphenylamine-Based D-D-π-A-type Fluorescence Dyes

Design, Synthesis and Optical Properties of Novel D - Π - a Compounds

The synthesis and photophysical properties of novel triphenylamine derivatives containing α, β-diarylacrylonitrile

Twisted D–π–A Solid Emitters: Efficient Emission and High Contrast Mechanochromism

Highly Fluorescent Emitters Based on Triphenylamine‐π‐Triazine (D‐π‐A) System: Effect of Extended Conjugation on Singlet‐Triplet Energy Gap

Triarylborane-terminalized Branched Π-Conjugative Dyes: Synthesis, Structure and Optoelectronic Properties

Star-shaped D-π-A Compounds with a 1,3,5-Triazine Core and N-aryl Chromophore Substituted Fluorene Arms: Synthesis, Aggregation Induced Emission and Two-Photon Absorption

Novel A–π–D–π–A Type Molecules Based on Diphenylamine and Carbazole with Large Two-Photon Absorption Cross Section and Excellent Aggregation-Induced Enhanced Emission Property

Asymmetrical/Symmetrical D−π–A/D−π–D Thiazole-Containing Aromatic Heterocyclic Fluorescent Compounds Having the Same Triphenylamino Chromophores

Bis(Triphenylamine)Benzodifuran Chromophores: Synthesis, Electronic Properties and Application in Organic Light-Emitting Diodes

The synthesis, properties and theoretical study of D-A-D structured triphenylamine chromophores with different acceptors

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

A New Fluorescent Triphenodioxazine Dye Derived from 4-Aminodiphenylamine

Synthesis and fluorescence property modulation of α-cyano-1,4-diphenylbutadiene derivatives containing triphenylamine structure

Aggregation-Induced Emission and Large Two-Photon Absorption Cross-Sections of Diketopyrrolopyrrole (DPP) Derivatives

9-Anthryl-capped DPP-based Dyes: Aryl Spacing Induced Differential Optical Properties

Investigations and Facile Synthesis of a Series of Novel Multi-Functional Two-Photon Absorption Materials

Triphenylamine Based Benzimidazole and Benzothiazole: Synthesis and Applications in Fluorescent Chemosensors and Laser Dyes

Synthesis and Efficient Solid-State Emission of Conjugated Donor–acceptor–donor Triphenylamine Chromophores

The synthesis and photoluminescence characteristics of novel α,β-diarylacrylonitrile derivatives containing both a biphenyl group and a triphenylamine unit