Antenna Design for Ferromagnetic Resonance and Spin Wave Spectroscopy

Yiheng Rao,Dainan Zhang,Lichuan Jin,Zhiyong Zhong,Qinghui Yang,Mingming Li,Jie Li,Yan Yang,Gang Wang,Gongwen Gan,Huaiwu Zhang

DOI: https://doi.org/10.1016/j.jmmm.2019.165442

IF: 3.097

2019-01-01

Journal of Magnetism and Magnetic Materials

Abstract:This paper presents a comprehensive study of antennas based on co-planar waveguides (CPW) for ferromagnetic resonance (FMR) detection and spin wave spectroscopy in ferromagnetic insulators. We studied the FMR detection waveguide for both flip-chip method and on-chip waveguide. An antenna can work with low-wave vectors on commercial substrates such as RO4003/Al2O3 and ferromagnetic insulators such as yttrium iron garnet. A higher value of wave vector k is required by antennas to excite spin wave with a shorter wavelength, which strongly depends on the width of the antenna. A co-plane waveguide antenna can excite k(1) between 0 and 6 rad/mu m with the spin wave group velocity and excitation-spectrum width Delta k = 3.58 rad/mu m and inner signal line 0.5 mu m. The value of k(1) for antenna excited spin wave using a 0.5 mu m short-circuit line of CPW varied between 0 and 7 rad/mu m with Delta k = 1.98 rad/mu m. Antennas with different width (0.5-10 mu m) were also studied. Meander-shaped short-circuit lines were designed to modify the k vector. The maximum amplitude of the k vector of the designed antenna appeared at k(3) approximate to 3 rad/mu m for the line width of 0.5 mu m.