Abstract:The Quasi-Impedance-Source Inverter (Quasi-Z inverter) is an interesting DC-AC converter topology that can be used in applications such as fuel cells and photovoltaic generators. This topology allows for both boost capability and DC-side continuous input current. Another very interesting feature is its reliability, as it limits the current when two switches on one leg are conducting simultaneously. This is due to an extra conduction state, specifically the shoot-through state. However, the shoot-through state also causes a loss of performance, increasing electromagnetic interference and harmonic distortion. To address these issues, this work proposes a modified carrier-based control method for the T-Type single-phase quasi-Z inverter. The modified carrier-based method introduces the use of two additional states to replace the standard shoot-through state. The additional states are called the upper shoot-through and the lower shoot-through. An approach to minimize the number of switches that change state during transitions will also be considered to reduce switching losses, improving the converter efficiency. The proposed modified carrier-based control strategy will be tested using computer simulations and laboratory experiments. From the obtained results, the theoretical considerations are confirmed. In fact, through the presented results, it is possible to understand important improvements that can be obtained in the THD of the output voltage and load current. In addition, it is also possible to verify that the modified carrier method also reduces the input current ripple.

Carrier-based modulation algorithm of fault-tolerant three-phase four-switch inverter for better current performance

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

A Zero-Voltage Switching Three-Phase Inverter

Generalized Space-Vector-Modulation Method for Soft-Switching Three-Phase Inverters

Equivalence of SVM and Carrier-Based PWM in Three-Phase/Wire/Level Vienna Rectifier and Capability of Unbalanced-Load Control

Current Ripple Optimization of Four-Phase Floating Interleaved DC–DC Boost Converter Under Switch Fault

Generalized Space Vector Modulation for Ripple Current Reduction in Quasi-Z-Source Inverters

An improved modulation algorithm for the dual‐output six‐switch inverter with reduced switching frequency

The Equivalent Relationship between Space Vector and Carrier-based PWM Modulation Strategy in Current Source five-level Inverters

Improved Carrier-Based Modulation for the Single-Phase T-Type qZ Source Inverter

Comparison of four carrier-based PWM methods for two-level five-phase inverter

A Space Vector Modulation Strategy for Improving Voltage Transfer Ratio of Multi-Phase Inverter

The study of SPWM control strategy to reduce common-mode interferences in three-phase four-leg inverters

Optimised Phase Disposition Pulse-Width Modulation Strategy for Hybrid-Clamped Multilevel Inverters Using Switching State Sequences

Assessment of vertical shifted carrier schemes for sinusoidal pulsewidth modulation

Modified Hybrid Modulation Scheme with Even Switch Thermal Distribution for H-Bridge Hybrid Cascaded Inverters

Integrated Modulation of Dual-Parallel Three-Level Inverters With Reduced Common Mode Voltage and Circulating Current

Modulation method of parallel interleaved three-level inverter considering neutral point potential and phase current balance

A Common-Mode Voltage Reduction PWM Strategy for Three-Phase Quasi-Z-Source Inverter With Optimized Switching Losses

Sawtooth Carrier-Based PWM Methods With Common-Mode Voltage Reduction for Symmetrical Multiphase Two-Level Inverters With Odd Phase Number

Common-Mode Voltage Reduction Method for Three-Level Inverter With Unbalanced Neutral-Point Voltage Conditions