Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Equivalency of Different Load Models Based on Volterra Online Parameter Identification

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Two Parameter Estimation & Simulation

Parameters identification of practical load model with voltage phase considered

Load Modeling with Considering Frequency Characteristic

Mechanism Analysis of Power Load Using Difference Equation Approach

Parameter Identification of the Synthesis Load Model Considering Distribution Impedance and Compensation Capacitor

New method for on-line modelling of electric loads

On-line identification of power system dynamic equivalent: Part One: Models and Identifiability

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

Identifiability and Identification of a Synthesis Load Model

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

A Low-order Simplified Model of Power-electronic-interfaced Loads

A new generalized load model of power systems and its applications

An Online Adjustment Method of Dynamic Equivalent Model Based on Additional Fictitious Impedances and Ant Colony Optimization Algorithm

A Composite Induction Motor Load Model for Conversion Between Different Voltage Sides Through the Transmission Element

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Component Based On-line Modeling for Electric Loads

Improvements and measurements of parameter identification for electric load

Identification of a composite load model with applications

Fast Online Identification of the Dominant Parameters of Composite Load Model Using Volterra Model and Pattern Classification

Key Techniques for Composite Load Area Integral Equivalence and Online Parameter Identification