Abstract:We have developed a simple method for the direct analysis of two‐dimensional trabecular structure. Using this method, we have compared the structure of the left and right iliac crest and the second lumbar vertebra and studied the relationship between two‐dimensional trabecular structure and the ultimate compressive stress of bone samples from the second lumbar vertebra. Transverse cores were taken from the left and right iliac crests and second lumbar vertebrae of 35 subjects (12 females) who died suddenly. The trabecular structure was subdivided into nodes (node count) and free ends (free end count), which were expressed per square millimeter of cancellous space. A node was defined as the point of junction between two or more trabeculae; a free end was defined as the end of a trabecula that was unconnected in the plane of the section to any other trabecular element. The following struts were defined by drawing a line between the nodes and the free ends: node to node, node to free end, free end to free end, and cortex‐derived struts. Strut lengths were measured and expressed as a percentage of the total strut length and per square millimeter of cancellous space. Intra‐observer variation was generally low, with coefficients of variation for repeat measurements in the range 3.9–17.8%. There was no statistically significant difference between left and right iliac crests for any of the variables measured. With the exception of cortex‐derived struts, there was no statistically significant correlation between crests for any variable. When compared to the second lumbar vertebra, the iliac crest had a greater node count and node‐to‐node strut length, indicating a higher degree of connectedness. There was a significant correlation between the lumbar vertebra and iliac crest for node count and node‐to‐node strut length. Variables measured in the second lumbar vertebra correlated well with ultimate compressive stress, the strongest correlations being with free end‐to‐free end strut length (r = ‐0.75, p < 0.0005) and node‐to‐free end strut length (r = 0.76, p < 0.0002). In both the second lumbar vertebra and iliac crest, node count, node‐to‐node strut length, and free end‐to‐free end strut length correlated significantly with age. The method reported here requires inexpensive equipment and is reproducible. Two‐dimensional trabecular structure in the iliac crest has greater connectedness compared to that in the second lumbar vertebra, although there is a relationship between the two sites. The structural variables measured in the lumbar vertebra are indicative of ultimate compressive stress at that site. Similar relationships between the structural variables and age are seen in the iliac crest and second lumbar vertebra. This type of analysis should provide important quantitative information concerning the changes in trabecular structure with age and in disease, as well as the ability of different drug treatments to improve trabecular structure.

Construction and Characterization of Genotype-3 Hepatitis C Virus Replicon Revealed Critical Genotype-3-specific Polymorphism for Drug Resistance and Viral Fitness.

The Relationship Between Electromigration-Induced Short-Circuit and Open-Circuit Failure Times in Multi-Layer VLSI Technologies

Development of Full-Length Cell-Culture Infectious Clone and Subgenomic Replicon for a Genotype 3a Isolate of Hepatitis C Virus

Studies of interaction phenomena in aqueous-based film coatings containing soluble additives using thermal analysis techniques.

Full-length sequence analysis of hepatitis C virus genotype 3b strains and development of an in vivo infectious 3b cDNA clone

A new manual method for assessing two‐dimensional cancellous bone structure: Comparison between iliac crest and lumbar vertebra

Who Really Benefits from Agricultural Subsidies? Evidence from Field‐Level Data

Resistance Mutations Against HCV Protease Inhibitors and Antiviral Drug Design.

Pharmacophore-Assisted Covalent Docking Identifies a Potential Covalent Inhibitor for Drug-Resistant Genotype 3 Variants of Hepatitis C Viral NS3/4A Serine Protease

Analysis of the susceptibility of refractory hepatitis C virus resistant to nonstructural 5A inhibitors

[Pneumocystis carinii pneumonia in AIDS: retrospective analysis of 80 documented cases (1985-1993)].

Amino Acid Substitutions in Genotype 3a Hepatitis C Virus Polymerase Protein Affect Responses to Sofosbuvir

Analysis of drug-resistance-associated mutations and genetic barriers in hepatitis C virus NS5B sequences in China

Insertion Of Green Fluorescent Protein Into Nonstructural Protein 5a Allows Direct Visualization Of Functional Hepatitis C Virus Replication Complexes In Living Cells.

Direct-acting Antiviral Agents Resistance-associated Polymorphisms in Chinese Treatment-naïve Patients Infected with Genotype 1b Hepatitis C Virus.

Combination treatment with hepatitis C virus protease and NS5A inhibitors is effective against recombinant genotype 1a, 2a, and 3a viruses

[From pharmacogenetics to pharmacogenomics: the start of a new era of personalized medicine in nephrology].

Optical visualization of microsomal degranulation by a carcinogen.

Computational Study on the Drug Resistance Mechanism against HCV NS3/4A Protease Inhibitors Vaniprevir and MK-5172 by the Combination Use of Molecular Dynamics Simulation, Residue Interaction Network, and Substrate Envelope Analysis

Construction and expression of plasmids containing the truncated core protein of different quasispecies genotype 1b hepatitis C virus

A Quantitative High-Resolution Genetic Profile Rapidly Identifies Sequence Determinants of Hepatitis C Viral Fitness and Drug Sensitivity