Abstract:Abstract This paper focuses on the reconfiguration of a 3-(rR)PS metamorphic parallel mechanism based on complete workspace and operation mode analysis. The mechanism consists of three (rR)PS legs, and each (rR) joint is composed of two perpendicular revolute joints. One of the (rR) joint axes can be reconfigured continuously, which allows the mechanism to exhibit three distinct configurations. Initially, the constraint equations are derived by using algebraic geometry approach, and the primary decomposition is computed for the three configurations. It reveals that the 3-(rR)PS metamorphic parallel mechanism can exhibit one up to two operation modes among three configurations. When the second axes of the three (rR) joints intersect at a finite point and not coplanar, the 3-(rR)PS metamorphic parallel mechanism has only one operation mode. If the second axes of the three (rR) joints are coplanar, the 3-(rR)PS metamorphic parallel mechanism has two operation modes. It is shown that both operation modes have the same motion type, namely, 1T2R motion. However, to realize the same trajectories in both operation modes, the moving platform will have different orientations. Hence, the orientation workspaces of both operation modes are characterized and the axodes are used to compare the instantaneous motion of the moving platform when passing through the same trajectories. Based on these results, an identification approach is introduced to identify which operation mode a given mechanism pose belongs to and this provides a useful method for trajectory planning.

Operation Mode Comparison of Three 1T2R Parallel Mechanisms Based on Geometric Constraints

Reconfiguration of a 3-(rR)PS Metamorphic Parallel Mechanism Based on Complete Workspace and Operation Mode Analysis

Motion Characteristics Analysis of a Novel 2R1T 3-UPU Parallel Mechanism

Design and analysis of a class of two-limb non-parasitic 2T1R parallel mechanism with decoupled motion and symbolic forward position solution - influence of optimal arrangement of limbs onto the kinematics, dynamics and stiffness

Kinematics Performance Comparison of a Family of 3-RPS Parallel Mechanisms Affected by Limb Arrangement

Type Synthesis of Non-Overconstrained and Overconstrained Two Rotation and Three Translation (2R3T) Parallel Mechanisms with Three Branched Chains

Optimal Type Selection of 1T2R Parallel Mechanisms Based on Motion/force Transmissibility

A new 3-DOF 2T1R parallel mechanism: Topology design and kinematics

Analysis and Optimization of a Novel Planar 5R Parallel Mechanism with Variable Actuation Modes

A Comparison Study of Two Planar 2-DOF Parallel Mechanisms: One with 2-RRR and the Other with 3-RRR Structures.

Kinematic Performance Analysis and Promotion of a Spatial 3-Rpas Parallel Manipulator with Multiple Actuation Modes

Dynamic Modeling and Experimental Verification of an RPR Type Compliant Parallel Mechanism with Low Orders

Design and Motion Principle Analysis of new parallel mechanisms with fewer active inputs than the degrees of freedom

Type synthesis of single-loop 3T1R-parallel mechanisms with a multi-DOF drive system

Type Synthesis of 2T1R Planar Parallel Mechanisms and Their Moduling Development Applications

Kinematics Analysis of a Novel 2r1t Parallel Mechanism

Kinematics and Inverse Dynamics Analysis for a Novel 3-PUU Parallel Mechanism.

2PPaRR-2PPaRU: Design, analysis, and optimization of a new 3T1R parallel manipulator with rotational pitch motion

A Novel 3-PUU Parallel Mechanism and Its Kinematic Issues

Design and analysis of a novel 3T1R four-degree-of-freedom parallel mechanism with infinite rotation capability

Elastostatic stiffness modeling and performance evaluation of a 2RPU-UPU parallel mechanism with two operation modes