Abstract:The Main objective of this study is to obtain a model that can explain the surface wave data and Bouguer gravity anomaly simultaneously and also to alleviate the non-uniqueness of surface wave inversion. We applied a novel non-linear joint inversion technique using both surface wave and gravity anomalies to obtain high resolution 3D shear-wave velocity crustal model of Central North China Craton including Shanxi graben. The crustal model helps us to understand the crust and mantle dynamics and the evolution history of the Shanxi rift. We bandpass filtered WGM2012 global Bouguer gravity anomaly data to remove the data with wavelength less than 50 km and greater than 200 km. We then projected the gravity data and surface wave data from ambient noise tomography to a Cartesian coordinate system with grid spacing 50 km x 50 km. The joint inversion was performed in this coordinate system. The inversion volume is much larger than the target region. This parameterization strategy was chosen to minimize the likelihood edge effects from gravity modelling. We used Crust 2.0 global model as our initial model in the inversion. An approximate non-linear P velocity and density relationship is derived from combing Birch's law and Nafe-Drake's curve. For each iteration of inversion, the sensitivity kernel of surface wave and gravity data were recalculated and updated until the inversion converged. We did several experiments to obtain an optimized weighting parameter to balance the influences of both datasets. A surface-wave-only inversion was also performed to compare the results of joint inversion. Both shear wave velocity models from joint inversion and surface-wave-only inversion can fit surface wave data well though only the joint inversion provides an acceptable fit to the gravity data. Gravity misfits decrease from >30 mGal to similar to 3.4 mGal after joint inversion. The velocity anomalies from both inversions all show a remarkable correlation with surface geology and upper crustal structures beneath Shanxi rift. The Luliang mountain region and Datong volcanic region all show relatively high shear wave velocity in the upper crust. Meanwhile, the basins in the southern rift show slow velocities. The southern part of the Shanxi rift is slower than the northern part in the upper crust. The Cenozoic extension started from the northern rift and then passed on to the southern rift. However, in the mid-and-lower crust beneath the Datong volcanic region, the surface-wave-only inversion resolves much slower shear wave velocity compared to the joint inversion model. The most pronounced difference occurs in the mid-and-lower crust beneath the Luliang mountain region. The joint inversion reveals a slow velocity anomaly with amplitude about 2%, while the surface-wave-only inversion model shows a fast velocity. The Datong volcanic region, north part of the Shanxi rift, might have experienced mantle upwelling since the Cenozoic time. The hot and buoyant mantle heated the upper most mantle and the crust, which caused the large-scale mid and lower crust slow velocity and negative gravity anomaly in the Datong volcanic region. The slow velocity anomaly beneath the Luliang mountain region is also related to the mantle upwelling beneath the Datong volcanic region. The Cenozoic mantle upwelling might control the formation and evolution of the Shanxi rift.

Inverting Rayleigh Surface Wave Velocities for Crustal Thickness in Eastern Tibet and the Western Yangtze Craton Based on Deep Learning Neural Networks

Three‐dimensional Lithospheric S Wave Velocity Model of the NE Tibetan Plateau and Western North China Craton

High-resolution Lithospheric Structure Beneath Mainland China from Ambient Noise and Earthquake Surface-Wave Tomography

Crust and Upper Mantle Structure of East Asia from Ambient Noise and Earthquake Surface Wave Tomography

Two crustal low-velocity channels beneath SE Tibet revealed by joint inversion of Rayleigh wave dispersion and receiver functions

Deep Learning Inversion of Rayleigh-wave Dispersion Curves with Geological Constraints for Near-Surface Investigations

Three-dimensional crustal model of Shanxi graben from 3D joint inversion of ambient noise surface wave and Bouguer gravity anomalies

Simultaneous Joint Inversion of Surface Wave and Gravity Data for Revealing 3-D Crustal S-wave Velocity and Density Structures: a Case Study of the NE Tibetan Plateau

Joint tomographic inversion of crustal structure beneath the eastern Tibetan Plateau with ambient noise and gravity data

Nonlinear travel-time inversion for 3-D complex crustal velocity structure

A New Crustal Shear-Velocity Model in Southwest China from Joint Seismological Inversion and Its Implications for Regional Crustal Dynamics

The Lithospheric-Scale Deformation in NE Tibet from Joint Inversion of Receiver Function and Surface Wave Dispersion

Qinghai-Tibet Plateau Crustal Thickness Derived from EGM2008 and CRSUT2.0

Lithosphere Structure and Thickness Beneath the North China Craton from Joint Inversion of Ambient Noise and Surface Wave Tomography

A Deep-Learning-based Approach for Seismic Surface-Wave Dispersion Inversion (sfnet) with Application to the Chinese Mainland

Inversion of Gravity and Topography Data for the Crust Thickness of China and Its Ad-Jacent Region

Plateau crustal thickness derived from EGM 2008 and CRSUT 2 . 0

Joint Inversion for Crustal and Pn Velocities and Moho Depth in Eastern Margin of the Tibetan Plateau

Inversion of the Density Structure of the Lithosphere in the North China Craton from GOCE Satellite Gravity Gradient Data

Crustal and upper mantle velocity structure of SE Tibet from joint inversion of Rayleigh wave phase velocity and teleseismic body wave data

A New Method to Constrain Shallow Crustal S-wave Velocities Based on Direct P-wave Amplitudes in Receiver Functions and Its Application in Northeastern Tibet