Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Electric polarization tune enhanced photoelectrochemical performance of visible light active ferroelectric Bi0.5Na0.5TiO3 nanostructure photoanode

Ferroelectric Spontaneous Polarization Assisted TiO2@BaTiO3@Ag Photoanode for Efficient Photoelectrochemical Water Splitting Via BaTiO3 Phase Regulation

Piezoelectric‐Effect‐Enhanced Full‐Spectrum Photoelectrocatalysis in P–n Heterojunction

High Performance BiFeO3 Ferroelectric Nanostructured Photocathodes

A dual optimization approach for photo-electric catalysis: Heterojunction of BiOBr/Ba0.7Sr0.3TiO3 system construction and ferroelectric polarization

Reconstructing Ferroelectric Polarization Screening of PbTiO3 by Epitaxial SrTiO3 for Efficient Photocatalytic Overall Water Splitting

Surface ferroelectric polarization promotion on photoelectrochemical oxygen evolution by transparent P(VDF-TrFE)

Ferroelectric Polarization-Induced Performance Enhancements in BiFeO3-Based Photoanodes for Photoelectrochemical Water Splitting

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Enhanced photocurrent in ferroelectric Bi0.5Na0.5TiO3 materials via ferro-pyro-phototronic effect

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Semiconductive‐Ferroelectric‐Enhanced Photo‐Electrochemistry with Collective Improvements on Light Absorption, Charge Separation, and Carrier Transportation

Polarization‐Modulated Photovoltaic Effect at the Morphotropic Phase Boundary in Ferroelectric Ceramics

Ferroelectric polarization controlled surface potential and charge transport across ITO-Nd-doped BiFeO 3 polycrystalline ceramic bulk for photoelectrochemical solar water splitting

Polarization-induced internal electric field to manipulate piezo-photocatalytic and ferro-photoelectrochemical performance in bismuth ferrite nanofibers

Epitaxial Bi2 FeCrO6 Multiferroic Thin Film as a New Visible Light Absorbing Photocathode Material.

Epitaxial Bi2FeCrO6 Multiferroic Thin-Film Photoanodes with Ultrathin P-Type NiO Layers for Improved Solar Water Oxidation.

Improving charge separation efficiency and piezo-photodegradation properties in Na0.5Bi0.5TiO3 via lattice engineering

Photochromism-promoted high efficient photocatalytic degradation in ferroelectric photochromics

Insights on the Origination of Ambipolar Photocurrent of Ferroelectric and the Improvement of Photoanodic Current

Activating a TiO 2 /BiVO 4 Film for Photoelectrochemical Water Splitting by Constructing a Heterojunction Interface with a Uniform Crystal Plane Orientation