Abstract:Tsinghua Thomson scattering X-ray (TTX) source, proposed by Tsinghua University, is a hard x-ray source with multi-application in condensed matter physics and other applications. The TTX is composed of an S-band photocathode RF gun and a SLAC type 3m travelling wave Linac, and a femto-second tera-watt laser system. The TTX source is in operation. To extend the capability of TTX, we plan to design a ring based system to increase the average photon flux. In this paper, we report the design of the 4.8 m electron storage ring and optical cavity, expected performance, and future prospects. INTRODUCTION Inverse Compton Scattering is a physical effect which can transfer energy from electrons to photons. Hard xray, which is in dozens of keV range, can be generated by head-on collision between low energy photons and MeV electrons. Tsinghua Thomson scattering X-ray source was started in 2001, which consists of an S-band photocathode RF gun, an S-band 3m SLAC type travelling wave linac, and a tera-watt laser system [1]. In previous experiments, the number of generated X-ray photons, which is measured with MCP, is about 1 × 10photons/pulse [2]. The repetition frequency is 10 Hz. For generating stable x-ray output and increasing the photon flux, a compact electron storage ring and an optical cavity are proposed. In this scheme, the electron beam is stored in a small ring while laser pulses are stored and enhanced in an optical cavity. The repetition frequency is the same as the revolution frequency of the electron beam in the ring of the order of magnitude of tens of MHz. In this paper, we present the current design of the compact electron storage ring and optical cavity. THE ELECTRON STORAGE RING DESIGN Lattice We propose to use a 4-dipole scheme in the design of this 4.8 m ring. The bending radius of dipoles is 0.25 m. Two quadrupoles are put opposite to each other to change the damping partition number. As shown in Fig. 1 and ∗Work part supported by NSF PHYS 1205431 and DOE DE-FG0212ER41800 † xhs05@mails.tsinghua.edu.cn Fig. 2, both betatron tune and horizontal damping partition number can be varied by adjusting the strength of the quadrupoles and the edge angle of dipoles. Tune should be chosen carefully in order to avoid the harmful linear and nonlinear resonances. 0 0.5 1 1.5 2 0 0.5 1 1.5 2 Qx Q z Colorbar means K 1Q =0[m]~40[m] 0 5 10 15 20 25 30 35 40 Edge Angle=33 Edge Angle=35 Edge Angle=37 Edge Angle=39 Edge Angle=41 Figure 1: Tune diagram by changing the edge angle of 0 5 10 15 20 25 30 35 40 −0.2 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6

Dual-energy electron storage ring

Multiple Energy Storage Rings

Storage-ring Electron Cooler for Relativistic Ion Beams

Dynamic Simulation for Low Energy Compton Scattering Gamma-Ray Storage Ring

A novel design of the electrostatic storage ring using quadrupole deflector

Predominantly electric storage ring with nuclear spin control capability

Experimental Study of Synchro-Betatron Coupling Induced by Dipole Modulation

Novel Concept of Circular-Linear Energy Recovery Accelerator to Probe the Energy Frontier

Sustainable early-stage lasing in a low-emittance electron storage ring

Physics issues in diffraction limited storage ring design

Lattice design for a low energy electron storage ring

Ultralow Longitudinal Emittance Storage Rings

Off-energy operation for the Extremely Brilliant Source at the European Synchrotron Radiation Facility

LOW ENERGY COMPACT STORAGE RING DESIGN FOR COMPTON GAMMA-RAY LIGHT SOURCE

The Cryogenic Storage Ring CSR

Experimental Study of a Two-Color Storage Ring FEL

Design and Dynamic Studies for a Compact Storage Ring to Generate Gamma-Ray Light Source Based on Compton Backscattering Technique

Beam dynamics driven design of powerful energy recovery linac for experiments

Laser electron storage ring for ttx∗

On Possibilities of High Precision Fundamental Physics Experiments in Spin-Transparent Storage Rings of Low Energy Polarized Electron Beams

Design of a Hybrid Ten-Bend-achromat Lattice for a Diffraction-Limited Storage Ring Light Source