Abstract:The present report describes the preparation and characterization of large-bore particle-entrapped monolithic precolumns, which are suitable for incorporation into a two-dimensional liquid chromatography (2D-LC) system for proteome analysis. The fritless precolumns with different inner diameter (i.d.) (320 and 530μm) were rapidly and successfully prepared by entrapping octadecylsilica (ODS) particles (5μm, 300Ǻ) prepacked into fused silica capillaries with a sol–gel network, which was formed by hydrolysis and polycondensation of methyltriethoxysilane (MTES). By optimizing the composition of the sol solution, the resulting large-bore monolithic precolumns of 5mm length allow a flow rate of 20μL/min loading buffer at a reasonable low back pressure of 25bar or less and are capable of withstanding up to 300bar inlet pressure. Scanning electron micrograms of the precolumns profile showed that the evolving sol–gel network joined particles to each other and onto the column wall, and no cracking or shrinkage of the column bed was observed even in 530μm-i.d. capillary. The performance of the particle-entrapped monolithic precolumns used for preconcentration and desalting of proteolytic digest was evaluated by on-line coupling the large-bore precolumns with a capillary reversed-phase liquid chromatographic (RPLC) column followed by UV detection. The laboratory-made monolithic precolumns with 320 and 530μm i.d. were characterized by using BSA tryptic digest or peptide standards as the analytes with respect to sample loading capacity, linearity, recovery and reproducibility, etc. The results indicate that the large-bore and short precolumns (5mm×320μm i.d. or 5mm×530μm i.d.) allow sample fast loading at a flow rate of 30 or 60μL/min. The precolumns also have a mass loading capacity for BSA peptides of about 70μg and for standard peptides of about 80μg. Good linear calibration curves (R2>0.99) were obtained and the limits of detection (signal-to-noise ratio, S/N=3) were improved by more than 60-fold and were between 0.53 and 1.32ng/μL even with a UV absorbance detector. The total recovery was found to be approximately 90–100% for BSA digest and standard peptides. The day-to-day relative standard deviation (RSD) values for recoveries of BSA peptides on a single precolumn ranged from 4.66 to 7.56% and 2.68 to 3.05% for precolumn back pressure, while the column-to-column RSD values were 3.51–6.13% and 1.22–1.26% for recoveries of BSA peptides and precolumn back pressure, respectively. With good precolumn reproducibility, no significant degradation or decrease in precolumn performance was showed even after ∼150 preconcentration/desorption cycles. The precolumns also proved to be resistant to salt buffer with high concentration and low-pH mobile phase. The large-bore particle-entrapped monolithic precolumns will be further used in a high-throughput 2D-LC array system coupled with tandem matrix assisted laser desorption/ionization-time of flight–time of flight–mass spectrometry (MALDI-TOF–TOF–MS) detection for proteome analysis.

Fast Reversed-Phase Liquid Chromatographic Separation of Proteins by Flow-Through Poly(styrene-Co-divinylbenzene) Microspheres.

Rapid Separation of Proteins by Capillary HPLC on a Short Polymethacrylate‐based Strong Cation‐exchange Monolithic Column

Fast liquid chromatography method for separation of peptides using a sub‐2 μm ground silica monolith packed column

Stop-flow Reversed Phase Liquid Chromatography × Size-Exclusion Chromatography for Separation of Peptides.

On-line Parallel Reversed Phase Two-Dimensional Liquid Chromatography for High-Throughput Analysis of Complex Proteomic Samples

Immunoaffinity separation of plasma proteins by IgY microbeads: meeting the needs of proteomic sample preparation and analysis.

Optimization Of Two-Dimensional High Performance Liquid Chromatographic Columns For Highly Efficient Separation Of Intact Proteins

Surfactant-bound monolithic columns for separation of proteins in capillary high performance liquid chromatography

Fast construction of polymer monolithic columns inside fluorinated ethylene propylene (FEP) tubes for separation of proteins by reversed-phase liquid chromatography

Preparation of a Capillary Isoelectric Focusing Column with Monolithic Immobilized Ph Gradient and Its Application on Protein Separation Based on an Online Capillary Isoelectric Focusing Platform.

High‐speed Separation of Proteins by Sodium Dodecyl Sulfate‐capillary Gel Electrophoresis with Partial Translational Spontaneous Sample Injection

Electrophoretic Separation with 2-Mm Inner Diameter Fused-Silica Microcolumn Packed with Quartz Microncrystals and Its Application

Bimodal gigaporous polystyrene microspheres with glycopolymer surfaces for high-speed protein chromatography

Large-Bore Particle-Entrapped Monolithic Precolumns Prepared by A Sol-Gel Method for On-Line Peptides Trapping and Preconcentration in Multidimensional Liquid Chromatography System for Proteome Analysis

Mixed-mode Reversed Phase/positively Charged Repulsion Chromatography for Intact Protein Separation

Utilizing Heterostructured Porous Particles to Improve Traditional Paper Chromatography for Spontaneous Protein Separation

A fast stop-flow two-dimensional liquid chromatography tandem mass spectrometry and its application in food-derived protein hydrolysates

The Polystyrene-Divinylbenzene Stationary Phase Modified with Poly (Amine-Epichlorohydrin) for Ion Chromatography

Imidazole-octyl mixed-mode stationary phase based on macroporous silica for the purification of ovomucoid and ovotransferrin

Integrated Protein Analysis Platform Based on Column Switch Recycling Size Exclusion Chromatography, Microenzymatic Reactor and Μrplc–esi-Ms/ms

Fast Preparation And Evaluation Of Cross-Linked And Surface Boned Polyacrylamide Coated Column For Capillary Electrophoresis