Abstract:This work investigates the effects of gas preheating and N2 dilution on soot formation in a series of laminar methane (CH4), ethane (C2H6), and propane (C3H8) co-flow diffusion flames. A modified Santoro-type burner was used to produce the flames with a series of preheat temperatures of both co-flow air and inlet fuels between 293 and 723 K. Planar laser-induced incandescence and line-of-sight beam extinction were employed to quantitatively measure the planar distributions of soot volume fractions, and two-color pyrometry was used to measure the soot temperature. The results show that the soot volume fraction significantly increases with the gas preheat temperature for all flames. A rise in the preheat temperature accelerates soot evolution and leads to the higher percentage of carbon conversion to soot in the flames. This enhancement is more remarkable in the flames of fuel with a lower sooting propensity than those with a high sooting propensity. Both axial and radial soot temperatures in the CH4 and C2H6 flames increase with the gas preheat temperature significantly. However, a reverse changing trend is observed in the central region of C3H8 flames, owing to the greater heat losses resulting from the incomplete combustion and strong soot radiation. Adding N2 to the fuel flow suppresses soot formation via the direct dilution effect on the fuel concentration and the indirect effect of changing the flame temperature. As the gas preheat temperature increases, an increasing proportion of the contribution of the direct dilution effect is observed in the N2-diluted C2H6 flames. In addition, the global activation energy of soot formation for the three fuels is estimated on the basis of the measured soot temperature and soot formation rate in the present work.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03426?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03426</a>.Calculated pyrolysis products for (a) CH4, (b) C2H6, (c) N2-diluted (50%) C2H6, (d) C3H8, and (e) N2-diluted (66.7%) C3H8 under different temperatures (Figure S1), relationship between laser fluence and normalized LII signal intensity (Figure S2), vertical laser fluence profile of the laser sheet where the laser fluence was set as approximately 0.3 J/cm2 (Figure S3), and calibrated relationship between soot volume fraction (fv) and LII signal intensity at the height from 15 to 40 mm in the propane flame IV-0, with the solid line representing the fitting curve to the experimental data and the two short dashed lines representing the boundaries of ±15% uncertainty in the fitting correction factor (Figure S4) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03426/suppl_file/ef0c03426_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Effects of soot inception and condensation PAH species and fuel preheating on soot formation modeling in laminar coflow CH4/air diffusion flames doped with n-heptane/toluene mixtures

Assessment of Physical Soot Inception Model in Normal and Inverse Laminar Diffusion Flames

Chemical Suppressive Effect of Ammonia Addition on Soot Formation in Laminar Diffusion Flames

Soot Modeling of Counterflow Diffusion Flames of Ethylene-Based Binary Mixture Fuels

Numerical Study of Soot Formation in Laminar Coflow Diffusion Flames of Methane Doped with Primary Reference Fuels

Experimental and simulation studies on flame characteristics and soot formation of C2H2 jet flames

An Experimental and Modeling Study on Sooting Characteristics of Laminar Counterflow Diffusion Flames with Partial Premixing

Large Eddy Simulation of Soot Formation in a Turbulent Lifted Flame with a Discretized Population Balance and a Reduced Kinetic Mechanism

Effects of Flame Temperature on PAHs and Soot Evolution in Partially Premixed and Diffusion Flames of a Diesel Surrogate

Effects of Air and Oxy-Fuel Atmospheres on Flamelet Modeling of Pollutant Formation in Laminar Counterflow Solid Fuel Flames

Assessing PAHs-based soot inception models in various laminar non-premixed flame configurations

A comparative study on soot and PAH formation of C10 naphthenic ring-containing species in laminar coflow diffusion flames

Compositional effects on PAH and soot formation in counterflow diffusion flames of gasoline surrogate fuels

The Effects of 1-Methylnaphthalene Addition to N-Dodecane on the Formation of Soot and Polycyclic Aromatic Hydrocarbons in Laminar Coflow Diffusion Flames

Effects of Combustion Models on Soot Formation and Evolution in Turbulent Nonpremixed Flames

Effects of the Gas Preheat Temperature and Nitrogen Dilution on Soot Formation in Co-flow Methane, Ethane, and Propane Diffusion Flames

Effect of Hydrogen and Helium Addition to Fuel on Soot Formation in an Axisymmetric Coflow Laminar Methane/air Diffusion Flame

Effects of Simultaneous Hydrogen Enrichment and Carbon Dioxide Dilution of Fuel on Soot Formation in an Axisymmetric Coflow Laminar Ethylene/air Diffusion Flame

Experimental and Detailed Kinetic Modeling Study of PAH Formation in Laminar Co-Flow Methane Diffusion Flames

Large Eddy Simulation of Soot Formation in a Laboratory Pulverized Coal Flame

Development of a Phenomenological Soot Model Coupled with a Skeletal PAH Mechanism for Practical Engine Simulation