Abstract:Abstract Nano particle-assisted engineered water is one of the newest hybrid methods of Enhanced Oil Recovery (EOR) that is gaining attention in the oil and gas industry. This is attributed to the low cost of the technique and environmental friendliness of the materials involved. Low salinity and ions adjustment of the injection brine has been reported to be very useful for improving oil production in carbonates, and application of nanoparticles (NPs) to improve oil recovery via different mechanisms such as wettability alteration, interfacial tension reduction, disjoining pressure and viscosity modification. This paper therefore investigates the combined effects of these two techniques on oil-brine-rock (OBR) interactions in carbonate reservoirs. Caspian Sea Water salinity of 13000 ppm was synthesized in the laboratory, potential determining ions such as Mg2+, Ca2+ and SO42- were adjusted to obtain the desired engineered waters used as dispersant for SiO2 nanoparticle. A series of experiments were performed ranging from zeta potential, interfacial tension, contact angle, electron scanning environmental imaging, pH analysis and particle size to determine the optimum formulation of engineered low salinity brine and nanoparticle. The salinities and concentration of NP considered in this experimental study ranges between (3,250 - 40,000) ppm and (0.05 - 0.5) wt.%, respectively. It was observed that optimum homogenization time for achieving stability of the chosen nanofluid without using stabilizer is 45 minutes. Four times sulphate and calcium ions in the engineered water reduced the contact angle from 163 to 109 and 151 to 118 degrees respectively. However, in the presence of NP, the contact angle further reduced to a very low values of 5 and 41 degrees. This confirms the combined effects of EW and that of nanofluid (NF) in altering wettability from the hydrophobicity state to hydrophilicity one that rapidly improves oil recovery in carbonate reservoir. IFT measurements were made between oil and formation brine as well as between oil and different EWs at room temperature. The Formation water has the least value of interfacial tension- 15mN/m. Four times diluted sea water spiked with four times sulphate is denoted as 4dsw4S. The zeta potential values showed dsw4S-NF to be the most stable, whereas EW-NF spiked with 4 times Mg2+ show detrimental effects on NF stability. The nanoparticles sizes were measured to be less than 50 nm. Rheological studies of the EW-NF at different temperatures (25, 40, 60 and 80 degrees Celsius) shows similar trend of Newtonian and non-Newtonian behavior at shear rate less than 100 and above 100 per seconds respectively. We conclude that spiking calcium ion and sulphate ion into the injected brine in combination with 0.1wt% NP yielded the wettability alteration in carbonate rock samples. The significant reduction in wettability is attributed to the combined effects of the active mechanisms present in the hybrid method and is considerably better than each standalone technique.

Experimental Investigation of Wettability Alteration and Oil Recovery Enhance in Carbonate Reservoirs Using Iron Oxide Nanoparticles Coated with EDTA or SLS

The Effect of Nano Heavy Metal Oxide Particles on the Wettability of Carbonate Reservoir Rock

Investigating Effect of SiO2 Nanoparticle and Sodium-Dodecyl-Sulfate Surfactant on Surface Properties: Wettability Alteration and IFT Reduction

Nanofluid-Induced Wettability Gradient and Imbibition Enhancement in Natural Porous Media: A Pore-scale Experimental Investigation

Metal oxide-based nanoparticles: revealing their potential to enhance oil recovery in different wettability systems

Integrating low salinity water, surfactant solution, and functionalized magnetite nanoparticles with natural acidic groups for enhanced oil recovery: Interfacial tension study

The comparison of interface properties on crude oil-water and rheological behavior of four polymeric nanofluids (nano-SiO2, nano-CaO, GO and CNT) in carbonates for enhanced oil recovery

Experimental evaluation of oil recovery mechanism using a variety of surface-modified silica nanoparticles: Role of in-situ surface-modification in oil-wet system

Synergistic Effects of Engineered Water-Nanoparticle on Oil/Brine/Rock Interactions in Carbonates

Synergistic Effect of MgO Nanoparticles and SDS Surfactant on Interfacial Tension Reduction for Enhanced Oil Recovery

Experimental Investigation of Silica-Based Nanofluid Enhanced Oil Recovery: the Effect of Wettability Alteration

Evaluation of Nanosilica Morphology: Effects on Nanofluid Stability and Interaction with Carbonate Rock Surfaces

Pore-scale experimental investigation of oil recovery enhancement in oil-wet carbonates using carbonaceous nanofluids

Evaluating the potential of surface-modified silica nanoparticles using internal olefin sulfonate for enhanced oil recovery

Stabilizing silica nanoparticles in high saline water by using ionic surfactants for wettability alteration application

The Influence of Nano Fluid Compared With Polyethylene Glycol and Surfactant on Wettability Alteration of Carbonate Rock

Synthesis of colloidal silica nanofluid and assessment of its impact on interfacial tension (IFT) and wettability for enhanced oil recovery (EOR)

Molecular dynamics modeling and simulation of silicon dioxide-low salinity water nanofluid for enhanced oil recovery

Comprehensive experimental investigation of the effective parameters on stability of silica nanoparticles during low salinity water flooding with minimum scale deposition into sandstone reservoirs

High Salinity and High Temperature Stable Colloidal Silica Nanoparticles with Wettability Alteration Ability for EOR Applications

Synthesis and application of eucalyptus plant- and walnut shell- CuO/Fe3O4/Xanthan polymeric nanocomposites for enhanced oil recovery in carbonate reservoirs