Abstract:Nucleation and growth of droplets onto seed particles and subsequent solidification is an emerging technique for fabrication of complex colloids with controlled particle morphology and chemical makeup. The technique is often implemented at or near equilibrium, where the final composite particle structure is determined by the equilibrium contact angles of the droplets on the seed particles. Here, we apply the technique out of equilibrium, utilizing the rich and intriguing morphologies emerged as a droplet is triggered to dewet on a rod along the free energy minimization pathway. Specifically, 3-trimethoxysilyl propyl methacrylate (TPM) droplets were nucleated and grown onto silica rods. Upon dewetting, the droplets undergo a series of morphology changes, starting from engulfing the rods, contracting to the center, moving sideways to finally being fully separated from the rods. Composite patchy particles of controlled configurations were achieved by stimulating a fast photopolymerization of the TPM droplets at desired stages of the morphology evolution. Through seed surface functionalization, the patches can be decorated by either the hydroxyl or the amine group, which are used to create fluorescently-patterned patchy particles. Combining with surface evolver simulations, we demonstrate that nonequilibrium solidification of droplets on rods can be used to synthesize two-patch particles with a larger range of control over the patch size than its equilibrium counterpart.

Synthesis of two-patch particles with controlled patch size via nonequilibrium solidification of droplets on rods