Effect of Wave Shaper on Reactive Materials Jet Formation and Its Penetration Performance

Huan-guo Guo,Yuan-feng Zheng,Le Tang,Qing-bo Yu,Chao Ge,Hai-fu Wang

DOI: https://doi.org/10.1016/j.dt.2019.05.005

IF: 4.035

2019-01-01

Defence Technology

Abstract:Wave shaper effect on formation behavior and penetration performance of reactive liner shaped charge (RLSC) are investigated by experiments and simulations. The reactive materials liner with a density of 2.3 g/cm(3) is fabricated by cold pressing at a pressure of 300 MPa and sintering at a temperature of 380 degrees C. Experiments of the RLSC with and without wave shaper against steel plates are carried out at standoffs of 0.5, 1.0, and 1.5 CD (charge diameter), respectively. The experimental results show that the penetration depths and structural damage effects of steel plates decrease with increasing the standoff, while the penetration depths and the damage effects of RLSC without wave shaper are much greater than that with wave shaper at the same standoff. To understand the unusual experimental results, numerical simulations based on AUTODYN-2D code are conducted to discuss the wave shaper effect, including the propagation behavior of detonation wave, the velocity and temperature distribution of reactive jet, and penetration depth of reactive jet. The simulations indicate that, compared with RLSC without wave shaper, there is a higher temperature produced inside reactive jet with wave shaper. This unusual temperature rise effects are likely to be an important mechanism to cause the initiation delay time of reactive jet to decline, which results in significantly decreasing its penetration performance. (C) 2019 Production and hosting by Elsevier B.V. on behalf of China Ordnance Society.