Abstract:A two-stage filtration test system was successfully developed previously, and the objective of this study is to investigate the effect of pre-filter selection and face velocity of pre-stage and main-stage on the loading characteristics of a two-stage filtration system. Three different types of pre-stage filter media with different capture efficiency, i.e., G3, G4 and M5 pre-filters, were selected as filter type variables. Three different face velocities on pre-stage, i.e., 26.3, 45.0 and 65.2 cm.s(-1), and three different face velocities on main-stage, i.e., 2.1, 3.6, 5.2 cm.s(-1) were chosen as face velocity variables. Self-defined indexing parameters were used to analyze the effect of pre-filter in this study. The experimental results indicated that although M5 pre-filter with the highest capture efficiency presents the best protection to mitigate the pressure drop growth of main-filter, the pressure drop of M5 pre-filter itself increases the fastest, resulting in the shortest effective protecting time of M5 pre-filter in front of a main-stage filter, so the overall effectiveness of M5 pre-filter fades out due to the limited protection period. On the other hand, G4 pre-filter can run for a relative longer time while maintaining the pressure drop of the whole two-stage filtration system to increase relatively slowly. G4 pre-filter achieves highest T** value, outperforming the lowest efficient G3 pre-filter by its higher efficiency and the highest efficient M5 pre-filter by longer effective protection period. With the decrease of face velocity on either the pre-stage or the main-stage, the effectiveness of pre-filter on main-filter and the whole two-stage filtration system improves, by slowing down the pressure drop increasing rate of main-stage filter, which further contributes to extend the service lifetime of the main-filter and increase dust holding capacity of the whole filtration system. Besides, the specific resistance k(2) of the dust cake formed on main-filter were found deeply affected by the main-stage face velocity. With the face velocity on the main-stage increased, the specific cake resistance k(2) increased obviously, which implies that the dusts structure on the main-filter changed and became more compacted under higher main-stage filtration velocity. To better illustrate the relatively importance between pre-filter grade and filtration velocity selection, the analyzed performance indexing parameters were further arranged in a set of contour plots, which unveils the predominance of pre-filter grade over filtration velocity within the variation ranges tested in current study.

Influence of Pre-Stage Filter Selection and Face Velocity on the Loading Characteristics of a Two-Stage Filtration System

Effect of main-stage filter media selection on the loading performance of a two-stage filtration system

Particle Loading Characteristics of a Two-Stage Filtration System

Influence of pleated geometry on the pressure drop of filters during dust loading process: experimental and modelling study

A numerical simulation method for pressure drop and normal air velocity of pleated filters during dust loading

Experimental Investigation of Air Pressure Affecting Filtration Performance of Fibrous Filter Sheet.

Effect of Pre-Cladding Dust Layer on Filtration and Pulse-Jet Cleaning Performance of Filter Media

Study on the Filtration Performance of the Baghouse Filters for Ultra-Low Emission as a Function of Filter Pore Size and Fiber Diameter

Performance characteristics of air intake pleated panel filters for internal combustion engines in a two-stage configuration

Experimental Testing of Filter Materials for Two-Stage Inlet Air Systems of Internal Combustion Engines

Study on Effects of Particle Size and Maximum Pressure Drop on the Filtration and Pulse-Jet Cleaning Performance of Pleated Cartridge Filter

Comprehensive evaluations of the bioaerosol filtration performance of high- and medium-efficiency filters under different influencing factors

Effects of Filter Cartridge Wetted Before Filtration and During Filtration on the Performance of Cartridge Dust Collector

Efficiency Characteristic Research of Nonstationary Filtration for Fibrous Filters

Filtration performance of glass fibrous air filter media under sinusoidal flow condition

Numerical study of pleated fabric cartridges during pulse-jet cleaning

Effects of the filter media pack configurations on the air filtration performance

Numerical study of opposing pulsed-jet cleaning for pleated filter cartridges

Numerical study of the effects of cartridge shape on the reverse pulsed flow cleaning of pleated cartridge filters

An analysis of a reverse pulse cleaning process using high-flow pleated fabric filter cartridges