Abstract:Considering the importance of ethanol (EtOH) as an engine fuel and a key component of surrogate fuels, the further understanding of its auto-ignition and oxidation characteristics at engine-relevant conditions (high pressures and low temperatures) is still necessary. However, it remains difficult to measure ignition delay times for ethanol at temperatures below 850 K with currently available facilities including shock tube and rapid compression machine due to its low reactivity. Considering the success of our recent study of toluene oxidation under similar conditions [38], dimethyl ether (DME) has been selected as a radical initiator to explore the low-temperature reactivity of ethanol. In this study, ignition delay times of ethanol/DME/'air' mixtures with blending ratios of 100% EtOH, 70%/30% EtOH/DME and 50%/50% EtOH/DME mixtures were measured in a rapid compression machine and in two high-pressure shock tubes at conditions relevant to internal combustion engines (20-40 atm, 650-1250 K and equivalences ratios of 0.5-2.0). The influence of these conditions on the auto-ignition behavior of the mixture blends was systematically investigated. Our results indicate that, in the low temperature range (650-950 K), increasing the amount of DME in the fuel mixture significantly increases the reactivity of ethanol. At higher temperatures, however, there is almost no visible impact of the fuel mixture composition, whereas DME shows a lower reactivity. Furthermore, with the addition of DME, different kinetic regimes were observed experimentally: the reactivity is controlled by ethanol when the addition of DME is less than 30% while it is dominated by DME when the proportion of DME is over 50%. Literature mechanisms show reasonable agreement with the new experimental data for the 100% EtOH and the 70%/30% EtOH/DME mixtures but under-predict the reactivity of the 50%/50% EtOH/DME mixtures at temperatures below 850 K, suggesting that further refinement of the low-temperature chemistry of ethanol/DME is warranted. An updated binary fuel mechanism is therefore proposed by incorporating the latest experimental and/or theoretical work in the literature, as well as adding new reaction pathways. Results indicate that the proposed model is in satisfactory agreement with all of the mixtures investigated. (C) 2017 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

An ultraviolet laser absorption diagnostic for ȮH concentration time-history in ethanol oxidation and model improvement

Experimental and Numerical Study on the Effect of Hydrogen Addition on Laminar Burning Velocity of Ethanol-Air Mixtures

Chemical Kinetics of H-Atom Abstraction from Ethanol by HȮ2: Implication for Combustion Modeling.

Mid-infrared absorption spectroscopy measurements and model improvements during the oxidation of ammonia/ethanol and ammonia/diethyl ether blends in a shock tube

Experimental study of the methane/hydrogen/ammonia and ethylene/ammonia oxidation: Multi-parameter measurements using a shock tube combined with laser absorption spectroscopy

A Further Experimental and Modeling Study of Acetaldehyde Combustion Kinetics

Development of a Detailed Kinetic Model for High-Pressure Ethanol Oxidation in Gas Phase and Supercritical Water

The kinetic model of ethylcyclohexane combustion over a wide temperature range and its comprehensive validation

Probing the Low-Temperature Chemistry of Ethanol Via the Addition of Dimethyl Ether

Measurements and modeling study of intermediates in ethanol and dimethy ether low-pressure premixed flames using synchrotron photoionization

A Study on Ethanol Oxidation Kinetics in Laminar Premixed Flames, Flow Reactors, and Shock Tubes

Experimental and Kinetic Modeling Study of the Low- and Intermediate-Temperature Oxidation of Dimethyl Ether

An Updated Reaction Model for the High-Temperature Pyrolysis and Oxidation of Acetaldehyde

From electronic structure to model application of key reactions for gasoline/alcohol combustion: Hydrogen-atom abstraction by CH 3 OȮ radicals

Acetaldehyde Oxidation at Low and Intermediate Temperatures: an Experimental and Kinetic Modeling Investigation

Experimental and Kinetic Modeling Study of Laminar Flame Characteristics of Higher Mixed Alcohols

An Experimental and Kinetic Modelling Study on Laminar Premixed Flame Characteristics of Ethanol/Acetone Mixtures

Species Diagnostics and Modeling Study of Laminar Premixed Flames Fueled by Acetone–butanol–ethanol (ABE)

Laser-absorption-spectroscopy-based temperature and NH<sub>3</sub>-concentration time-history measurements during the oxidation processes of the shock-heated reacting NH<sub>3</sub>/H<sub>2</sub> mixtures

Experimental and Modeling Efforts Towards a Better Understanding of the High-Temperature Combustion Kinetics of C3C5 Ethyl Esters

An experimental and kinetic modeling study on the ignition characteristics of ammonia/ethanol at high temperatures