Fabric-Based Insoles With Self-Equipped Sensors for the Foot's Physiological Signal Monitoring
Mi Zhou,Wenbin Jiang,Jinfeng Wang
DOI: https://doi.org/10.1109/jsen.2023.3346816
IF: 4.3
2024-02-16
IEEE Sensors Journal
Abstract:The quantification of plantar pressure distribution is widely used, such as diagnosis of lower limb deformity, gait analysis, and so on. Here, an insole based on warp-knit spacer fabric and graphene was proposed, which is lightweight, wireless, affordable, and user-friendly. The insole with five sensing areas greatly optimizes the number of sensors required to be used. For the insole as a whole, the insole has a large pressure detection range, that is, 5–120 kPa. The pressure detection limit can reach 5 kPa with a 0.08-s response time and a 0.07-s recovery time, and the gauge factor (GF) can be up to 63.500. It also has good pressure response durability. It can maintain stability after it is used continuously for more than 30 min (more than 200 tests). Surely, the insole's sensing performance under compression, bending, and tensile deformation that must bear when walking is excellent and timely, though the deformation degree and frequency changes applied on it. When placed in the shoe, the insole does not interfere with the user's gait. It can recognize different human movements, such as normal walking, fast walking, sitting, and standing. It provides a feasible solution for low-cost, accurate, real-time, and high-user comfort foot movement/exercise biomechanical information acquisition, injury prevention, and ulcer prediction.
engineering, electrical & electronic,instruments & instrumentation,physics, applied