DNA-templated Copper Nanoclusters As a Fluorescent Probe for Fluoride by Using Aluminum Ions As a Bridge

Jiawei Pang,Yuexiang Lu,Xinyu Gao,Liuying He,Jingwei Sun,Fengyi Yang,Zixuan Hao,Yueying Liu
DOI: https://doi.org/10.1007/s00604-019-3468-8
IF: 5.7
2019-01-01
Microchimica Acta
Abstract:A selective fluorescent on-off-on probe has have designed for the detection of fluoride (F−) ions based on DNA-templated copper nanocluster (CuNCs) and by using aluminum(III) ions as a bridge. A 40-mer polythymine acts as a template for the reduction of Cu(II) to Cu(0) by ascorbic acid. This result is the formation of red fluorescent CuNCs, with excitation/emission peaks at 340/640 nm. After addition of Al3+ ions, the fluorescence of CuNCs is quenched because the interaction of Al3+ and DNA disturbs the formation of DNA-templated CuNCs. Fluorescence is restored on addition of fluoride to the system. This is due to the desorption of Al3+ from the DNA and the formation of the Al(OH)3F− complex. This system displays a fast fluorometric response to fluoride, with high selectivity over other anions. Fluorescence increases linearly in the 2 to 150 μM F− concentration range, and the detection limit is 1.0 μM. This probe has been successfully used for the detection of F− ions in four brands of toothpaste. The method is rapid, cost-effective, selective, and does not require toxic solvents and reagents.
What problem does this paper attempt to address?