Abstract:Crystalline admixture (CA) is an effective self-healing agent for mortar. However, the effects of crack parameters (i.e. crack width and cracking age) and the service environment on the self-healing behavior of CA-containing mortar are not well understood. Herein, the self-healing behavior of mortar containing a self-developed CA was assessed by testing strength recovery, impermeability recovery, and crack closure in pre-cracked specimens. Three initial crack widths (0.2, 0.3, and 0.4 mm), five cracking ages (3, 7, 14, 28, and 56 days), and four external exposure conditions (humidity chamber, air exposure, water immersion, and wet-dry cycles) are investigated. Furthermore, the influence of different external conditions on the healing products at the region of crack and the pore structure of hardened paste containing CA are studied. The results show that adding 4.54% CA into mortar allows rapid healing of 300 μm-wide cracks. Although wider cracks (400 μm) are more difficult to heal, the sorptivity coefficients of the mortars with 400 μm-wide cracks after healing decrease. When the cracks are produced at an earlier age, the pre-cracked specimens have higher recovery ratios of strength and impermeability after healing, and the specimens pe-cracked at a later age still have acceptable compressive strengths after healing. The analysis shows that the strengths and impermeabilities of pre-cracked mortars containing CA exposed to the four external conditions are all recovered. The best self-healing performance is observed for the specimens exposed to water immersion and wet-dry cycles conditions. Somewhat less good self-healing was observed in the specimens exposed to humid chamber condition, while the worst self-healing performance was in the specimens exposed to air exposure condition. This study provides a theoretical basis for the application of novel CAs in cement-based materials.

Numerical Investigation on Interface Crack Initiation and Propagation Behaviour of Self-Healing Cementitious Materials

A two-dimensional micromechanical damage-healing model on microcrack-induced damage for microcapsule-enabled self-healing cementitious composites under tensile loading

An micro-level study on the cracking performance of encapsulation-based self-healing resin mineral composites under dynamic load based on XFEM

Investigating the Self-Healing Performance of Cracked Undersea Constructions

Assessment of self-healing behavior of polypropylene fiber-reinforced cement mortar with crystalline admixture: the effects of crack widths, cracking ages, and external conditions

An enhanced lattice beam element model for the numerical simulation of rate-dependent self-healing in cementitious materials

Self-healing Properties of Lightweight High-Toughness Cementitious Composites under Dry-Wetting Cycles

Visual and quantitative evaluation of crack bonding rate of self-healing mortars based on volumetric strain analysis

Multiscale and multiphysics discrete model of self-healing of matrix and interfacial cracks in fibre reinforced cementitious composites: Formulation, implementation and preliminary results

Mechanical responses of microencapsulated self-healing cementitious composites under compressive loading based on a micromechanical damage-healing model

Molecular Simulation Study on Mechanical Properties of Microcapsule-Based Self-Healing Cementitious Materials

Evaluation of the Self-Healing Ability of Mortar Mixtures Containing Superabsorbent Polymers and Nanosilica

Quantifying Crack Self-Healing in Concrete with Superabsorbent Polymers under Varying Temperature and Relative Humidity

Influence of Crystalline Admixtures and Their Synergetic Combinations with Other Constituents on Autonomous Healing in Cracked Concrete-A Review

Evaluation of crack closure by ultrasonic wave transmission

Crack sealing evaluation of self-healing mortar with Sporosarcina pasteurii: Influence of bacterial concentration and air-entraining agent

The Effects of Crystalline Admixture on the Self-Healing Performance and Mechanical Properties of Mortar with Internally Added Superabsorbent Polymer

Assessment of self-healing performance of cement-based materials incorporating ion chelator and industrial wastes

A Novel Method of Self-Healing in Cementitious Materials by Using Polyacrylic Hydrogel

Autogenously self-healable cementitious composite incorporating autolytic mineral microspheres: Hydration regulation and structural alteration

Evaluation of the self-healing effect in cement-based materials with embedded cementitious capsules by means of Acoustic Emission techniques