Abstract:This paper deals with the initial shape analysis, cutting-pattern analysis, surface accuracy measurement and modal testing of high-precision inflatable antennas reflectors that are intended for spaceflight applications. The initial shape analysis method, formulated on the basis of membrane theory and elastic mechanics, determines the required as-manufactured shape of the reflective surface of the antenna reflector. On the other hand, the cutting-pattern analysis method, with its formulation based on spring-mass representations, numerically calculates the required cutting pattern of the planar membrane gores that are to be assembled to form the 3-dimensional reflective surface. To validate the effectiveness of the proposed analysis methods, a 3.2-m antenna reflector model was designed, manufactured, and assembled for ground demonstration and testing. The reflective surface accuracy of this demonstration reflector model was measured by a photogrammetric measuring system. Shape adjustments of the reflective surface were performed by systematically adjusting the tension in the cables that were used to mount the reflector to its support structure. It was found that the reflective surface accuracy of the reflector model, as defined by its RMS error from a best-fit parabolic shape, was less than 1mm. In addition, dynamic and RF tests were also performed on the demonstration reflector model. The test results indicated that the first-mode frequency of the reflector model agreed well with the corresponding analytical prediction, and its radiation pattern was also well focused.

Reflector Surface Alignment Based on Antenna Gain Measurements under Perturbations

Reflector Surface Precision Experiment of Deployable Truss Antenna

Structure design and mechanical measurement of inflatable antenna

Reflector design and precision measurement of inflatable antenna

An Active Reflector Antenna Using A Laser Angle Metrology System

Surface detection method for large active reflector antennas based on even-odd phase expansion

Study on the Near-Field Holography Measurements of Slant-Axis Terahertz Antennas under Cassegrain Mode

Simultaneous Multifrequency Near-Field Radio Holography of Reflector Antennas

On the Antenna Illumination Effects in Monostatic Reflectivity Determination for Microwave Calibration Targets

A surface deformation measurement algorithm for reflector antennas based on complex geometrical optics

Surface Deformation Recovery Algorithm for Reflector Antennas Based on Geometric Optics

Deformation Measurement by Single Spherical Near-Field Intensity Measurement for Large Reflector Antenna

Light-tracing based surface deformation measurement strategy for large radio telescopes

Microwave Holography Measurement Based on the Active Surface System of Large Reflector Antenna

Progress of the Active Reflector Antenna Using Laser Angle Metrology System

Reflector Deformation Measurement and Correction Methodology of Large Antenna Based on Phased Array Feed

Active Optimization Adjustment for the Surface Accuracy of Spaceborne SAR Antennas

The measurement and modeling of gravitational deformation for large radio telescope based on wavefront perturbation method

Optimisation of Phase Factor in Phase Retrieval for Reflector Antennas with Active Surface

Optimization and accuracy analysis in pose measurement of the subreflectors of large antennas based on stereo structured light

Study on the Phase Factor of Phase Retrieval Algorithm for Surface Diagnosis of Large Reflector Antennas