Abstract:A multi-frequency locally resonant (LR) phononic plate is proposed in this paper. The phononic plate consists of periodic arrays of multiple double-cantilevered thin beams attached to a thin homogeneous plate. This proposed phononic plate is simplified and modeled using a plane wave expansion method to enable the calculation of flexural wave band structures. The band gap behavior of the phononic plate is analyzed comprehensively. In addition, an experimental specimen is fabricated using a square aluminum plate with a thickness of 0.9 mm and an area of 840 mm840 mm, and attached to the specimens as periodic arrays of two types of double-cantilevered thin beams made of the same material as the host plate. And the specimen is measured by using a scanning laser Doppler vibrometer to verify the theoretical predictions of band gaps. Investigations of this paper yield the following findings and conclusions: (1) Due to the interaction of low-frequency vibrational modes of attached multiple double-cantilevered beams and flexural vibration of the host plate, the proposed multi-frequency LR phononic plate can exhibit multiple low-frequency flexural wave band gaps (stop bands). It is also found that the band gaps of a multi-frequency LR phononic plate, especially those appearing in a lower frequency range, are generally narrower than that of a single-frequency LR phononic plate with the same type of double-cantilevered beams. (2) The frequency location of band gaps moves to higher frequency range when the thickness of the double-cantilevered beams is increased, or when the length of the double-cantilevered beams is decreased. It is also shown that a very small variation of the thickness (e. g., 0.1 mm) may lead to significant changes of frequency position of the band gaps. (3) When the width of the double-cantilevered beams is enlarged or the number of the double-cantilevered beams is increased, the lower band gap edge will move to a lower frequency range, while the upper band gap edge will move to a higher frequency range. This implies that the bandwidth of the band gaps is broadened. However, at the same time, it is shown that the central frequencies of the band gaps remain almost unchanged. (4) Experimental measurements of the fabricated specimen evidence the existence of two low frequency band gaps, and confirm that the flexural plate vibrations are significantly reduced in the predicted band gaps.

Band Gaps for Flexural Elastic Wave Propagation in Periodic Composite Plate Structures Based on a Non-Classical Mindlin Plate Model Incorporating Microstructure and Surface Energy Effects

Microstructure-dependent Band Gaps for Elastic Wave Propagation in a Periodic Microbeam Structure

An Inertant Elastic Metamaterial Plate with Extra Wide Low-Frequency Flexural Band Gaps

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Exact Solution to Band Structures of One-Dimensional Viscoelastic Functionally Graded Phononic Crystals

Band Gaps of Lamb Waves in One-Dimensional Piezoelectric Composite Plates: Effect of Substrate and Boundary Conditions

Wave Motion in Periodic Flexural Beams and Characterization of the Transition Between Bragg Scattering and Local Resonance

A non-classical Mindlin plate model incorporating microstructure, surface energy and foundation effects

Band Gaps of Lamb Waves Propagating in One-Dimensional Different Quasi-Periodic Composite Thin Plates

Band Gap Behaviours of Periodic Magnetoelectroelastic Composite Structures with Kagome Lattices

Surface effect on band structure of magneto-elastic phononic crystal nanoplates subject to magnetic and stress loadings

Numerical Modelling and Optimization of Two-Dimensional Phononic Band Gaps in Elastic Metamaterials with Square Inclusions

Low Frequency Band Gaps and Vibration Reduction Properties of A Multi-Frequency Locally Resonant Phononic Plate

Symmetry Breaking Induces Band Gaps in Periodic Piezoelectric Plates

Wave Dispersion in One-Dimensional Periodic Graded Metacomposites

Elastic wave attenuation in a metaplate with periodic hollow shapes for vibration suppression

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Mechanically tunable band gaps in compressible soft phononic laminated composites with finite deformation

Free Vibrations of FG-GPLRC Magneto–Electro–Elastic Sandwich Cantilevered Trapezoidal Plates with Variable Thickness

Complete Band Gaps for Lamb Waves in Cubic Thin Plates with Periodically Placed Inclusions

Numerical and experimental analysis of the vibration and band-gap properties of elastic beams with periodically variable cross sections