Abstract:This study investigates the performance of Nichrome coatings, a nickel‐chromium alloy containing 20 wt.-% chromium, applied using three thermal spray techniques: powder plasma spray, suspension HVOF, and filament HVOF. Thin, homogeneous coatings approximately 35 μm thick were deposited onto steel substrates pre-coated with an insulating Al 2 O 3 layer. The oxide content in the coatings varied based on the spraying technique and parameters, ranging from 57 to 64 vol.-% for plasma spraying, 42 to 54 vol.-% for filament HVOF, and 9 to 43 vol.-% for suspension HVOF. The coating's heating performance was evaluated over a temperature range of room temperature (RT) to 700 °C. Analytical techniques such as X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), and Energy Dispersive X-ray Spectroscopy (EDS) were employed to investigate the mechanisms affecting temperature-dependent resistivity in relation to the coating microstructure. The results indicate that increased oxidation leads to a decrease in specific resistivity at RT ( ρ 0 ). In example, plasma sprayed coatings exhibited lower specific resistivity ρ 0 of 0.80 Ωmm 2 /m. In contrast, suspension HVOF reaches values up to 2.75 Ωmm 2 /m. At the same time coatings with higher oxidation levels demonstrate an elevated dependence of resistivity as compared to less oxidized coatings. Both can be attributed to changes in the phase composition of the conductive phase as the dominating factor, primarily driven by the preferential oxidation of chromium during the spraying process. Notably, the results provide valuable information for adjusting the coating properties to suit specific needs, such as self-regulating or high-temperature heating applications.

Study on Heating Model and Heat Transfer Law of Anti-Oxidation Coating Materials in High Vacuum Environment

Radiative Thermal Coats for Passive Temperature Management

Modelling the heat transfer of an antioxidant coating heating system in wide temperature and simulation

Dielectric Performance of Oxidation Ceramic Coating for High Temperature Insulation

Study of Resistance Performance of Al2O3–ZnO–Y2O3thermal Control Coating Exposed to Vacuum-Ultraviolet Irradiation

Mechanical Behavior of Anti-Oxidation Coatings on C/C Composites at Elevated Temperature: an In-Situ Indentation Study

High-temperature Oxidation and Gas Thermal Shock Studies of IC10 Simulated Specimens with Thermal Barrier Coatings

Study of high-entropy oxide diffusion barrier and diffusion resistance mechanism in high-temperature protective coatings

Comprehensive study on the microstructure evolution and oxidation resistance performance of NiCoCrAlYTa coating during isothermal oxidation at High temperature

Research Progress on High-Temperature Oxidation and Corrosion Mechanisms of Aluminide Coatings

Effect of Voltage on the Microstructure and High-Temperature Oxidation Resistance of Micro-Arc Oxidation Coatings on AlTiCrVZr Refractory High-Entropy Alloy

Experimental Investigation and Numerical Simulation for Corrosion Rate of Amorphous/Nano-Crystalline Coating Influenced by Temperatures

Mechanical, Tribological and Oxidation Resistance Properties of Ni-based Self-Lubricating Composite Coatings at Elevated Temperature by APS

Investigation on Oxidation and Interdiffusion in the Systems of Aluminiferous Coatings and Superalloys

High temperature properties of nichrome resistant heaters – A systematic comparison of APS, suspension and filament HVOF sprayed coatings

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

Research Progress in Chemical Vapor Deposition for High-Temperature Anti-Oxidation/ablation Coatings on Thermal Structural Composites

High-temperature Oxidation Behavior and Mechanism of the Si-based Thermal Protective Coating for SiCf/SiC Composites under Static Oxidation and H2O/O2/Na2SO4 Corrosion Oxidation

Investigation of oxide scale formation and internal oxidation of an Fe-based coating at 500 °C and 600 °C

Investigation of High Temperature Oxidation Behavior and Tribological Performance on Cold Sprayed Nickel–alumina Composite Coating

High Emissivity Coatings for High Temperature Application: Progress and Prospect