Self-Assembly of Monodispersed Carnosine Spherical Crystals in a Reverse Antisolvent Crystallization Process

Yanan Zhou,Jingkang Wang,Ting Wang,Na Wang,Yan Xiao,Shuyi Zong,Xin Huang,Hongxun Hao

DOI: https://doi.org/10.1021/acs.cgd.8b01818

IF: 4.01

2019-01-01

Crystal Growth & Design

Abstract:Spherical crystallization is an effective way to increase particle size, raise bulk density, and improve flowability and compressibility of crystals with small sizes, especially needle-like and flake-like microcrystals. In this work, a reverse antisolvent crystallization method was used to obtain the spherical crystals of carnosine instead of commercially available needle-like carnosine material. Besides, the solubility of carnosine in a binary solvent mixture of water + ethanol was measured at temperatures ranging from 288.05 to 323.15 K by using a gravimetric method under atmospheric pressure to optimize this crystallization process and increase the yield of carnosine. On the basis of these thermodynamic data, single factor analysis in a reverse antisolvent crystallization process was performed, including carnosine aqueous solution concentration, feeding rate, volume ratio of solution to antisolvent, temperature, and stirring speed. Polarizing microscopy, particle size distributions, and in situ particle vision measurements were used to characterize and monitor the carnosine spherical crystals during the reverse antisolvent crystallization process. Finally, monodispersed, several hundred micrometer-sized carnosine spherical crystals with a higher bulk density (0.224 g/mL) and smaller repose angle (39 degrees), which indicated better flowability, were successfully crystallized, and a feasible formation mechanism was proposed.