Abstract:Electrochemical double layer capacitors (EDLCs), are energy storage devices featuring many advantages, including long cycle life, low internal resistance, and high power densities (i.e. fast charge/discharge rates). Due to these advantages EDLCs have drawn much attention recently, and have been applied to electric/hybrid vehicles, heavy-construction equipment, electronics, and grid utility storage. The most common electrode material for EDLCs is porous activated carbon with the advantages of low cost, abundant resources, and simple processing. In this present work, carbon materials for EDLCs were hydrothermally synthesized from low-cost bio-polymer precursors. Hydrothermal synthesis (HTS) uses simple equipment and runs under mild conditions; the process also uses environmentally friendly precursors and does not produce any hazardous waste. HTS provides a facile method for the development of inexpensive, high- performance carbon materials. In this work, low cost precursors were obtained locally. The precursors were ground and mixed with DI water, and the solution was then sealed in a Teflon lined pressure vessel. The pressure vessel was heated to 200 °C for 24 hours. After the reactor cooled down, the as-synthesized carbons were harvested by filtration and dried in an oven at 120 °C overnight. The morphology of the as-synthesized carbons was characterized by scanning electron microscopy (SEM) as shown in Figure 1. The as-synthesized carbons went through a one-step activation, which increased the surface area to over 1000 m2/g, with 70% micro porosity. Electrodes were made, and tested in 1.8M TEMABF4in PC and 38% sulfuric acid. Cyclic voltammetry (CV) and galvanostatic charge-discharge tests were run on these activated carbons to study the electrochemical performance. The activated carbons showed very nice capacitor characteristics such as rectangular CV curves and very fast charge-discharge rates in both organic and aqueous electrolytes, as shown in Fig 2. The specific capacitance of these materials in organic electrolyte was ~90-120 F/g and had a volumetric capacitance of ~40-60 F/cc, while in aqueous electrolyte the gravimetric capacitance ranged from 180-200 F/g and 100-120 F/cc.

Crosslinked Quaternized Poly(Arylene Ether Sulfone) Copolymer Membrane Applied In An Electric Double-Layer Capacitor For High Energy Density

Hydroxypolybenzimidazole Electrolyte with Excellent Stability for High Power Density All-Solid-State Supercapacitors

Quaternary Ammonium Functionalized Poly(arylene Ether Sulfone)/poly(vinylpyrrolidone) Composite Membranes for Electrical Double-Layer Capacitors with Activated Carbon Electrodes

A Novel Poly(Ethylene Glycol)-Grafted Poly(Arylene Ether Ketone) Blend Micro-Porous Polymer Electrolyte For Solid-State Electric Double Layer Capacitors Formed By Incorporating A Chitosan-Based Liclo4 Gel Electrolyte

A High Energy Density Flexible Solid-State Supercapacitor Based on Poly (arylene Ether Sulfone) Copolymers with Polyether Side Chains for Li+ Conducting Polymer Electrolytes

A High-Performance Carbon-Carbon(c/c) Quasi-Solid-State Supercapacitor with Conducting Gel Electrolyte

Dilute Aqueous Hybrid Electrolyte Endows a High-Voltage Window for Supercapacitors

Improving the Pore-Ion Size Compatibility Between Poly(ionic Liquid)-Derived Carbons and High-Voltage Electrolytes for High Energy-Power Supercapacitors

A Flexible Supercapacitor with High Energy Density Driven by MXene/Deep Eutectic Solvent Gel Polyelectrolyte

Polymeric cathode materials of electroactive conducting poly(triphenylamine) with optimized structures for potential organic pseudo-capacitors with higher cut-off voltage and energy density

Electric double-layer capacitors with tea waste derived activated carbon electrodes and plastic crystal based flexible gel polymer electrolytes

An ultrahigh‐energy density and wide potential window aqueous electrolyte supercapacitor built by polypyrrole/aniline 2‐sulfonic acid modified carbon felt electrode

Development and Supercapacitor Application of Ionic Liquid-Incorporated Gel Polymer Electrolyte Films

Poly(Ionic Liquid) Derived Graphitic Nanoporous Carbon Membrane Enables Superior Supercapacitive Energy Storage.

Ionothermal Synthesis of Graphene-Based Hierarchically Porous Carbon for High-Energy Supercapacitors with Ionic Liquid Electrolyte

Synthesis of PVA/corn starch hydrogel polymer electrolytes for supercapacitors

Cross-Linking of Polymer and Ionic Liquid As High-Performance Gel Electrolyte for Flexible Solid-State Supercapacitors

Bio-Polymer Derived Activated Carbons for Electrochemical Double Layer Capacitors

Electrochemical Supercapacitor With Polymeric Active Electrolyte

The Development of Chitosan-Maltodextrin Polymer Electrolyte with the Addition of Ionic Liquid for Electrochemical Double Layer Capacitor (EDLC) Application

Flexible electric double-layer capacitors fabricated with micro-/mesoporous carbon electrodes and plastic crystal incorporated gel polymer electrolytes containing room temperature ionic liquids