Preparation of Biomass-Derived High Specific Surface Area Carbon with Titanium Nitride Nanoparticles for Lithium-Sulfur Batteries
Akmaral Dangaliyeva,Fail Sultanov,Aimira Urazgaliyeva,Batukhan Tatykayev,Zhumabay Bakenov,Almagul Mentbayeva
DOI: https://doi.org/10.1149/ma2024-0163053mtgabs
2024-08-09
ECS Meeting Abstracts
Abstract:The widespread challenges facing lithium-sulfur batteries, including the low electrical conductivity of sulfur and its species, electrode volume fluctuations during cycling, and the lithium polysulfides shuttle effect, have hindered their commercialization and practical utility [1,2]. Our study addresses these issues by incorporating titanium nitride (TiN) nanoparticles onto high specific surface area porous carbon, exploring this composite's potential as both a sulfur cathode host and separator modifier. The synthesis of the carbon/TiN composite involved two key stages: firstly, the in-situ growth of titanium dioxide (TiO 2 ) nanoparticles on the carbon surface utilizing titanium tetrachloride as a precursor; secondly, the conversion of the TiO 2 nanoparticles to TiN nanoparticles through carbothermal nitridization (thermal treatment at 1400 °C for 4 hours in a nitrogen medium) [3,4]. The lithium-sulfur cell employing the prepared C/TiN-25%@S cathode exhibited an initial discharge capacity of 1155 mAh g -1 at 0.2 C, maintaining a capacity exceeding 700 mAh g -1 after 100 cycles. Notably, the lithium-sulfur cell utilizing the C/TiN-25%@S cathode and a C/TiN-modified separator demonstrated enhanced cycling performance, delivering an initial discharge capacity of 1623 mAh g -1 with retention of over 1126 mAh g -1 after 100 charge/discharge cycles at 0.2 C. Acknowledgments This research was funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan (Grant No. AP19677708). References [1] D.-W. Wang, Q. Zeng, G. Zhou, L. Yin, F. Li, H.-M. Cheng, I.R. Gentle, G.Q.M. Lu, Carbon–sulfur composites for Li–S batteries: status and prospects, J. Mater. Chem. A 1 (2013) 9382. https://doi.org/10.1039/c3ta11045a. [2] M. Wang, X. Xia, Y. Zhong, J. Wu, R. Xu, Z. Yao, D. Wang, W. Tang, X. Wang, J. Tu, Porous Carbon Hosts for Lithium–Sulfur Batteries, Chem. Eur. J. 25 (2019) 3710–3725. https://doi.org/10.1002/chem.201803153. [3] S.A. Rezan, G. Zhang, O. Ostrovski, Effect of Gas Atmosphere on Carbothermal Reduction and Nitridation of Titanium Dioxide, Metall Mater Trans B 43 (2012) 73–81. https://doi.org/10.1007/s11663-011-9574-6. [4] X. Qin, J. Zhang, C. Ke, H. Chen, L. Zhao, Preparation of TiN ultrafine powders from sol-gel by Fe-catalyzed carbothermal reduction nitridation, Inorganic Chemistry Communications 148 (2023) 110278. https://doi.org/10.1016/j.inoche.2022.110278.