Abstract:This paper investigates the feasibility of coaxial deep borehole heat exchanger (CDBHE) applications to the University of California San Diego (UCSD) campus. By collecting different geophysical source data for various formations and well logs around the UCSD campus, a multilayered thermophysical model for the ground on the site is established. Water circulation within a closed coaxial loop system considers the geothermal energy extraction under uncertainty consideration of the unknown deeper layers heat flow gradient as coupled with the variation of pipe insulation properties, flow rates, outer pipe diameter, grout, and depths between 1 and 4 km. A finite-element framework models the Navier–Stokes fluid flow and heat transfer in the CDBHE system, validated with a field test on CDBHE from the literature. Results show that a 4-km CDBHE could produce a thermal power of 600 kW under the optimum geological conditions at the UCSD site: the water flow rate of 2.78 L/s and a ground thermal gradient of 60 °C/km. Thermal power shares from different layers indicate that deeper formation layers contribute more to the thermal power than the shallower layers because increasing the CDBHE length from 1 to 4 km can lead to a maximum of 900% increase in thermal power and a 50% expansion in thermal plume for a CDBHE with an insulated inner pipe between the upper and lower bound heat flow bounds. An inner pipe with an insulated depth of 2 km produces only 1–6% less power than a fully insulated inner pipe for the 4-km CDBHE, and thus, a partially insulated vacuum-insulated tube (VIT)-plastic inner pipe is suggested as the best practice. Furthermore, the CDBHE thermal power increases by 5% when the grout thermal conductivity increases from 1 to 3.65 W/(K∙m), close to the formation thermal conductivity, and then maintains almost the same, and the 4-km CDBHE with flow rates of 2.78–6.94 L/s at the UCSD site can directly supply a low-temperature heating radiator system for room heating. This study suggests practical ranges for geothermal energy extraction for southern California. A CDBHE with a well-insulated inner pipe of 0.05 W/(m∙K), the thermal power of lower and upper-bound heat flow cases can vary by 60% from the mean. Finally, water as the working fluid is more efficient than CO 2 , doubling CDBHE's thermal power. The effects of the investigated factors provide guidelines for future geothermal resource exploitation in southern California.

Centrifuge Simulation of the Thermal Response of a Dry Sand-Embedded Diaphragm Wall

Experimental Research on Heat Conduction and Temperature Control Method in the Chamber of Large-Scale Geotechnical Centrifuge

A Model of a Diaphragm Wall Ground Heat Exchanger

CENTRIFUGAL MODEL TESTS ON HYDRAULIC HEAVE MECHANISM OF EXCAVATION IN COHESIVE SOIL WITH CONFINED WATER

Thermo-mechanical Behavior of Energy Diaphragm Wall: Physical and Numerical Modelling

Finite Element Analysis of Thermal-Hydraulic Coupled Centrifuge Test for Saturated Sand

Energy diaphragm wall thermal design: The effects of pipe configuration and spacing

Performance Evaluation and Operation Mechanism of Deep Borehole Heat Exchanger with Different Types of Boundary Conditions

Centrifuge Modelling Of Active Earth Pressures

Direct-Coupling Simulation of Thermal-Hydraulic and Stress Analysis in a Cross-Wave Primary Surface Heat Exchanger

Long-term thermal performance analysis of deep coaxial borehole heat exchanger based on field test

Numerical Simulation of Geothermal Energy Development at Mount Meager and Its Impact on In Situ Thermal Stress

Uncoupled thermo-hydro-mechanical modeling of a pykrete diaphragm wall for an alternative artificial ground freezing application

Effects of Boundary Conditions on Performance Prediction of Deep-Buried Ground Heat Exchangers for Geothermal Energy Utilization

Heating test of a silty sand in a short cylinder with a vertical hydronic grouted heating pipe

The influence of geometry on the heat exchange potential of embedded planar retaining walls with seasonally-balanced thermal load

Feasibility of coaxial deep borehole heat exchangers in southern California

Performance Study of Silica Gel Coated Fin-Tube Heat Exchanger Cooling System Based on a Developed Mathematical Model

Testing a model of flow and heat transfer for u-shaped geothermal exchangers

Experimental study on heat storage characteristics of an air-sand moving bed heat exchanger

Numerical investigation of the deep borehole heat exchanger in medium-depth geothermal heat pump system for building space heating