Abstract:This study investigates the effects of diesel injection strategies on combustion, emissions, fuel economy and the operation range with high efficiency and low emissions fuelled with gasoline/diesel dual fuel on a modified single-cylinder diesel engine. This gasoline/diesel dual-fuel combustion mode proposes port fuel injection of gasoline and direct injection of diesel fuel with rapid in-cylinder fuel blending. Single and double injection strategies were employed in the engine experiments at 1500 rev/min and 50 mg/cycle total equivalent diesel fuelling rate. The experimental results showed that this combustion mode had the capability of achieving high efficiency with near zero NOx and soot emissions by using an early injection timing of single (E-single) strategy with high gasoline ratio (Rg). Parameters were optimized in double injection strategy included the first and second injection timing, injected diesel mass split between the two injections and the premixed gasoline ratio. Based on the optimized results, the comparison between single and double injection strategies was investigated. Compared to other three injection strategies, the early second injection timing (E-SOI2) strategy achieved the lowest indicated specific fuel consumption (ISFC) of 173 g/kW h, the NOx and soot emissions were below 0.2, 0.003 g/kW h respectively, but the maximum pressure rise rate (MPRR) was penalized, while the late second injection timing (L-SOI2) strategy was most favorable at reducing MPRR because of prolonged combustion duration. E-single and E-SOI2 strategies were difficult at high loads due to the high MPRR. Therefore, L-SOI2 strategy is an effective approach to expand the operation range to higher load. However, the upper load was limited by high soot emissions, which demanded increasing the diesel injection pressure. Under the operating conditions with optimized parameters, the maximum indicated mean effective pressure (IMEP) can be expanded up to 1.391 MPa by using L-SOI2 strategy with increased fuel mass while still maintaining good emissions and MPRR within a given criteria. (C) 2013 Elsevier Ltd. All rights reserved.

Optimization of the Combustion Chamber and Fuel Injection of a Diesel/Natural Gas Dual Fuel Engine

Methodology to Separate the Two Burn Stages of Natural-Gas Lean Premixed-Combustion Inside a Diesel Geometry

Optimization of a diesel/natural gas dual fuel engine under different diesel substitution ratios

Optimization of the injection parameters and combustion chamber geometries of a diesel/natural gas RCCI engine

On the optimization of the double-layer combustion chamber with and without EGR of a diesel engine

Numerical Optimization of Natural Gas and Diesel Dual-Fuel Combustion for a Heavy-Duty Engine Operated at a Medium Load

Optimization of the Direct Injection Natural Gas Engine under Different Combustion Modes

Optimization of the injection parameters of a diesel/natural gas dual fuel engine with multi-objective evolutionary algorithms

Multi-Objective Optimization Study of Dual-Fuel Engine Emissions and Economy

Computational Optimization of the Dual-Mode Dual-Fuel Concept Through Genetic Algorithm at Different Engine Loads

Multi-Objective Optimization of the Structural Design of a Combustion Chamber of a Small Agricultural Diesel Engine Fueled with B20 Blend Fuel at a High Altitude Area

Numerical investigation on the combustion and emission characteristics of a heavy-duty natural gas-diesel dual-fuel engine

Optimization of Combustion Chamber Geometry for Natural Gas Engines with Diesel Micro-Pilot-Induced Ignition

The multi-parameter optimization of injections on double-layer diesel engines based on genetic algorithm

Multi-Optimization of Injection Parameters Affecting Emissions in a Diesel Engine Fueled with Fischer–Tropsch Fuel Based on NSGA-II

Numerical Study on the Effect of the Combustion System Parameters on Combustion and Emission Characteristics for a HPDI Natural Gas/diesel Dual Fuel Engine

Experimental Investigation of the Effects of Diesel Injection Strategy on Gasoline/diesel Dual-Fuel Combustion

A full-parameter computational optimization of both injection parameters and injector layouts for a methanol/diesel dual-fuel direct injection compression ignition engine

Multi-objective Optimization of the Performance and Emission Characteristics for a Dual-Fuel Engine with Hydrogen Addition

Optimization of Injection Parameters for Diesel Engine during Transient Process Based on Response Surface Method and Genetic Algorithm

Analysis of the performance and emissions generation mechanism of natural gas/diesel dual-fuel under different strategies by combining experiments and mechanisms