Abstract:Slip often occurs in high-speed and light-load roller bearings (HSLLRBs) when the frictional drive force is inadequate to overcome the drag forces between the rolling elements and the raceway. Formerly, skidding analysis of HSLLRBs considering bearing whirling based on a simplified method using the Dowson-Higginson empirical model, although the analytical results of the cage slip fraction show significant discrepancies with the experimental data, as for extremely light radial loads. One of the main reasons is the inaccuracy of the evaluation of oil drag forces using the empirical equations. In this study, the elastohydrodynamic lubrication (EHL) method was adopted to calculate the oil film thickness and pressure distribution of HSLLRBs, so as to obtain more accurate oil drag forces. The cage speed and cage slip fraction were obtained by combining the whirl orbits, drag forces, load, kinematic equations and other related equations and then solved using the Newton-Raphson method. The skidding mechanism was investigated in terms of various operating parameters such as whirl orbit radii, radial load and viscosity. The results showed that the cage slip fraction and cage speed oscillate over time because of the whirl, which leads to an increase in the risk of bearing skidding damage. Under the extremely light load and high speed, the slip and influence of the whirl on bearing skidding increases as the whirl radius and radial load increases, while the viscosity shows a reverse trend. Therefore, in order to reduce slip and skidding damage, the whirl radius and radial load should be decreased suitably, while the viscosity should be increased moderately. A comparison between the calculated and experimental results shows that the proposed method is both feasible and valid.

Experimental Analysis and Modeling of the Effects of Oil–Air Lubrication Parameters on Bearings Friction Loss of High-Speed Motorized Spindle

Experimental Study on Frictional Loss of High-Speed Bearings Based on Free-Deceleration and Energy-Balance Methods

Experimental and numerical study on the mixed lubrication performances of a new bearing

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings

Modeling of ball bearing churning losses

HIGH SPEED MOTORIZED SPINDLE BEARING THERMAL ANALYSIS AND EXPERIMENTAL RESEARCH

Experimental and numerical exploration on the nonlinear dynamic behaviors of a novel bearing lubricated by low viscosity lubricant

Experimental and Simulation Analysis of Oil-Air Two-Phase Flow Characteristics in High-Speed Bearings

An Improved Quasi-Dynamic Analytical Method to Predict Skidding in Roller Bearings under Conditions of Extremely Light Loads and Whirling

Skidding and Spinning Investigation for Dry-Lubricated Angular Contact Ball Bearing under Combined Loads

A multiphase flow study for lubrication characteristics on the internal flow pattern of ball bearing

Study on Static Characteristics of Water-Lubricated Textured Spiral Groove Thrust Bearing Using Laminar Cavitating Flow Lubrication Model

Study on Rotor-Bearing Dynamic Performance of a Novel Motorized Spindle Supported by Water-Lubricated Hydrodynamic Spiral Grooved Bearings

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Coupling Study on Quasi-Static and Mixed Thermal Elastohydrodynamic Lubrication Behavior of Precision High-Speed Machine Spindle Bearing with Spinning

Research on the Lubrication Performance of Hydrostatic Thrust Bearings Considering Dynamic Pressure Effect and Oil Film Pressure Loss

Investigation on Air-Gap Friction Loss Within Built-In Motor for High Speed Motorized Spindle

Lubrication and Thermal Failure Mechanism Analysis in High-Speed Angular Contact Ball Bearing

Experimental Research on Oil-air Lubrication for Highs-peed Ball Bearing

A Simulation Analysis for Lubricating Characteristics of an Oil-Jet Lubricated Ball Bearing.