Abstract:In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. The comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Summary In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. The purpose of these inverters is to reduce the voltage stress on capacitors, diodes, and switches compared to other topologies. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. Furthermore, all equations of voltage and current of components to design the suitable amounts of capacitors and inductors are calculated. Then, the comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Also, the losses and efficiency of the proposed topology at different loads are fully given. Finally, a prototype of the proposed topology is designed, and its experimental results are provided to check the performance and correctness of the obtained equations in different operating modes.

Single‐stage Impedance Source Inverters with Quasi‐dc–dc Output Cell for Working in Dual Inductor Current Modes

Single-stage Power Factor Correction Converter with Coupled Input Current Shaping Inductor

High-Gain Quasi-Switched Boost Inverter with Single Inductor and Continuous Input Current

Modified Impedance-Source Inverter with Continuous Input Currents and Fault-Tolerant Operations

Soft-switching Z-source inverters with coupled inductor

Topology and Control of Four-Quadrant Dual-DC-Port Dual-Buck Inverters For Semi-Two-Stage DC–AC Power Conversion

A Switched Quasi-Z-Source Inverter with Continuous Input Currents

Energy Transfer Modes of the Quasi-Z-Source DC-DC Converter Considering Critical Inductance

Single Coupled-Inductor Dual Output Soft-Switching DC–DC Converters with Improved Cross-Regulation and Reduced Components

Second Harmonic Current Reduction of Dual Active Bridge Converter under Dual-Phase-shift Control in Two-Stage Single-Phase Inverter for Residential Energy Storage System

Two Parallel Converters with Small Interconverter Inductor for Elevator Drive System

A Novel Dual Buck and Boost Transformer-Less Single-Phase Grid-Tied Inverter

Direct Charge Control Method for Inverters in Discontinuous Conduction Mode

MHz Level Two-Stage ZVS DC-DC Converter with Wide Input and Output Voltage Ranges

An Enhanced-Boost Coupled-Inductor Impedance Network Inverter Without Limitation of Inductor Parameters

Single-Inductor Multiple-Input Multiple-Output Converter With Common Ground, High Scalability, and No Cross-Regulation

Enhanced-Boost Quasi-Z-Source Inverters With Two-Switched Impedance Networks

Current-fed quasi-Z-source inverter with coupled inductors

A new class of active impedance source inverter with low voltage stress on semiconductors

A Novel Non-Isolated Dual-Input Single-Output High Step-up DC/DC Converter with Coupled Inductors

New Discontinuous Space Vector Modulation Strategies for Impedance-Source Inverter with Superior Thermal and Harmonic Performance