Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

A Comprehensive Understanding of Enhanced Condensation Heat Transfer Using Phase Separation Concept

Eliminating Flooding by Phase Separation in Condenser Tube

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Condensation Heat Transfer Characteristics On The Outside Of Horizontal Smooth, Herringbone And Enhanced Surface 1eht Tubes

Convective Condensation in Three Enhanced Tubes with Different Surface Modifications

Condensation Characteristics of Flows in Newly Developed, Three-Dimensional Enhanced Heat Transfer Tubes

Analysis of Condensation and Evaporation Heat Transfer Inside 3-D Enhanced Tubes

Characteristics Analysis of Condensation outside Horizontal Tube Bundles and Novel Condensation Enhancement Method

Investigation on Flow Condensation of Refrigerant in Annulus of Smooth and Enhanced Tube-in-tube Heat Exchanger

Experimental Study on Condensation in the Outer Annular Region Outside Horizontal Enhanced Tubes

R410A and R32 condensation heat transfer and flow patterns inside horizontal micro-fin and 3-D enhanced tubes

R410A Flow Condensation Inside Two Dimensional Micro-Fin Tubes and Three Dimensional Dimple Tubes

Shell-Side Flow Condensation Heat Transfer on Three-Dimensional Enhanced Surface

In-Situ Phase Separation To Improve Phase Change Heat Transfer Performance

Experimental Investigation of Shell-Side Flow Condensation on Three-Dimensional Enhanced Surface Tubes

Experimental Study on Heat Transfer Performance and Flow Pattern in Micro-Fin Tubes and 1EHT Three-Dimensional Heat Exchange Tubes

An Experimental Study of R134a Condensation Heat Transfer in Horizontal Smooth and Enhanced Tubes

Convective Condensation Inside Horizontal Smooth and Microfin Tubes

Boiling and Condensation Two-Phase Flow Heat Transfer on Three-Dimensional Macroscale Surfaces with Microscale Structures