Abstract:The CIE color rendering (fidelity) index (CRI) has remained unchanged for over four decades. Most, if not all, of its components could be updated to more state-of-the-art methods. One of the most critical components of any color rendering (fidelity) metric is the test sample selection. This article therefore addresses the importance of uniform sampling of wavelength space to avoid selective optimizationthat is, taking advantage of the unequal contributions of different wavelength regions to the general color rendering scoreof light source spectral power distributions. It summarizes the development of a mathematical sample set with undistorted spectral sensitivity, the HL17 set. The set is used in a recently proposed update, the CRI2012 general color rendering index. To assess the impact of the spectrally uniform sample set on color fidelity scores, the CRI2012 index values for each of a set of 139 lamps were compared with those of the CIE CRI. In addition, the impact of updating the other components was investigated. A mean and maximum absolute difference of respectively 5.9 and 21.8 index units were found between the CRI2012 and CIE CRI, although the largest partrespectively 4.03 and 19.7 index unitswas shown to be the result of updating the color difference engine and the switch to the CIE 10 degrees observer. The analysis also indicated possible past spectral selective optimization of some warm-white tri-band fluorescent sources for high luminous efficacy of radiation (LER) and (just) sufficient CIE R-a values by taking advantage of the spectral nonuniformity of the CIE reflectance set. Adopting a spectrally uniform sample set in a color rendering metric therefore has important practical implications when designing light source spectra. Finally, possible updates and further improvements of the CRI2012 are briefly mentioned.

Perceived Colour Fidelity under LEDs with Similar R-f but Different R-a

The Prediction of Perceived Colour Differences by Colour Fidelity Metrics

Human Perceptions of Colour Rendition at Different Chromaticities

Experimental Validation of Colour Rendition Specification Criteria Based on ANSI/IES TM-30-18

Human Perceptions of Colour Rendition Vary with Average Fidelity, Average Gamut, and Gamut Shape

Evaluation Of Colour Fidelity Based Colour Rendering Indices

Testing Colour Rendering Indices

Evaluation of LED Sources Based on Colour Appearance Data

Preference among Light Sources with Different Duv but Similar Colour Rendition: A Pilot Study

The CRI2012 Color Fidelity Index and Its Practical Application

Quantifying the suitability of CIE D50 and a simulators based on LED light sources

Evaluation of Light Sources Based on Visual Colour Rendering

Perceptual Responses to Led Illumination with Colour Rendering Indices of 85 and 97

EFFECT OF LIGHT LEVEL ON COLOR PREFERNECE AND SPECIFICAITON OF LIGHT SOURCE COLOR RENDITION

Development of the Ies Method for Evaluating the Color Rendition of Light Sources

Museum Lighting: Design Main-Colour Based Colour Rendering Index

Review of Measures for Light-Source Color Rendition and Considerations for a Two-Measure System for Characterizing Color Rendition.

Light Sources with a Larger Gamut Area Can Enhance Color Preference under a Lower Light Level

Toward a Replacement of the CIE Color Rendering Index for White Light Sources

The Role of Presented Objects in Deriving Color Preference Criteria from Psychophysical Studies

Colour Preference Varies with Lighting Application