Abstract:Coda interferometry is an effective approach to retrieve empirical Green's functions and the influence of source factors is important to apply the interferometry. Through cross correlations of synthetics and real coda, we systematically analyze the effects of dip angle, azimuth and strike, and epicenter distribution on the extraction of empirical Green's functions (mainly the PKIKP2 and PKIIKP2 phases). Our results infer that the average signal-to-noise ratios of PKIKP(2)phase firstly increase, then decrease with the dip -angle increasing, and reach the maximum at the middle dip angle (similar to 45 degrees). Based on the analysis of the stationary point, this trend may be due to the fact that the major contribution of the extracted PKIKP2 phase is from the radial direction, while radiated energy along the radial direction from the dip-slip earthquake is the largest when the dip angle is similar to 45 degrees. Moreover, the extraction of Rayleigh waves severely depends on the azimuth but is not affected by the strike. When the epicenters locate near the great circle arc of the station-pairs, coda interferometry can retrieve clear Rayleigh wave, which is consistent with the stationary phase region of surface waves. For the PKIKP2 and PKIIKP2 phases, high signal-to-noise ratios of the waveforms can be reconstructed only when the epicenters are far away from the great circle arc of the station-pairs and the strike of the faults is nearly parallel to the linear array. Our calculation of the source radiation energy, to some extent, demonstrates that above setting of the azimuth and the strike can improve the retrieval of two core phases. Lastly, epicenter distribution can influence the extraction of the PKIKP2. The smaller the acute angle between the radial direction of the earthquake and the raypath of the PKIKP2 phase is, as well as the smaller distance, the higher the signal-to-noise ratios can be acquired.

An Improved Empirical Green Function Method to Extract Microseismic Signals

Improvement of Source Spectrum Fall‐Off for Simulating Ground Motion Using Stochastic Green’s Function Method

Improvement of Stochastic Green's Function Method for 3D Broadband Ground-Motion Simulation

Influence of source factors on extracting empirical Green's functions by coda interferometry

An improved method for microseismic source location based on grid search

The Monitoring of Microseismic Clusters from the Joint of the Reversed P and S Wave Fields

Surface-wave observations after integrating active and passive source data

Arrival Picking And Global Refinement For Microseismic Events Based On Waveform Similarity

An Improved Method for Hydrofracture Induced Microseismic Event Detection and Phase Picking

Improved Methods for Detection and Arrival Picking of Microseismic Events with Low Signal-to-noise Ratios

Automatic Microseismic Event Detection and Arrival Picking Based on Waveform Cross-Correlation

Study Of Extracting Group Velocities Of Near-Surface Rayleigh Waves From Ambient Noise

Unveiling the Signals from Extremely Noisy Microseismic Data for High-Resolution Hydraulic Fracturing Monitoring

Application of Temporal Reweighting to Ambient Noise Cross-Correlation for Improved Seismic Green's Function

Arrival Picking Method for Microseismic Phases Based on Curve Fitting

Micro-seismic Elastic Reflection Full Waveform Inversion with An Equivalent Source

A high-resolution microseismic source location method based on contrast source algorithm

Master event based backazimuth estimation and its application to downhole microseismic monitoring

Green Functions Between Antipodal Station Pairs from Cross-Correlation of Ambient Noises

Waveform-based Microseismic Location Using Stochastic Optimization Algorithms: A Parameter Tuning Workflow

Improved Wavelet Packet Noise Reduction for Microseismic Data via Fuzzy Partition