Abstract:A multi-frequency locally resonant (LR) phononic plate is proposed in this paper. The phononic plate consists of periodic arrays of multiple double-cantilevered thin beams attached to a thin homogeneous plate. This proposed phononic plate is simplified and modeled using a plane wave expansion method to enable the calculation of flexural wave band structures. The band gap behavior of the phononic plate is analyzed comprehensively. In addition, an experimental specimen is fabricated using a square aluminum plate with a thickness of 0.9 mm and an area of 840 mm840 mm, and attached to the specimens as periodic arrays of two types of double-cantilevered thin beams made of the same material as the host plate. And the specimen is measured by using a scanning laser Doppler vibrometer to verify the theoretical predictions of band gaps. Investigations of this paper yield the following findings and conclusions: (1) Due to the interaction of low-frequency vibrational modes of attached multiple double-cantilevered beams and flexural vibration of the host plate, the proposed multi-frequency LR phononic plate can exhibit multiple low-frequency flexural wave band gaps (stop bands). It is also found that the band gaps of a multi-frequency LR phononic plate, especially those appearing in a lower frequency range, are generally narrower than that of a single-frequency LR phononic plate with the same type of double-cantilevered beams. (2) The frequency location of band gaps moves to higher frequency range when the thickness of the double-cantilevered beams is increased, or when the length of the double-cantilevered beams is decreased. It is also shown that a very small variation of the thickness (e. g., 0.1 mm) may lead to significant changes of frequency position of the band gaps. (3) When the width of the double-cantilevered beams is enlarged or the number of the double-cantilevered beams is increased, the lower band gap edge will move to a lower frequency range, while the upper band gap edge will move to a higher frequency range. This implies that the bandwidth of the band gaps is broadened. However, at the same time, it is shown that the central frequencies of the band gaps remain almost unchanged. (4) Experimental measurements of the fabricated specimen evidence the existence of two low frequency band gaps, and confirm that the flexural plate vibrations are significantly reduced in the predicted band gaps.

Tunable flexural wave band gaps in a prestressed elastic beam with periodic smart resonators

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Tuning Bandgaps in Metastructured Beams: Numerical and Experimental Study

Wide Band-gaps in Finite Timoshenko Locally Resonant Beams Carrying Periodic Separated Force and Moment Resonators: Forced Vibration Analysis Based on an Exact Wave-Based Approach

Tunability of resonator with pre-compressed springs on thermo-magneto-mechanical coupling band gaps of locally resonant phononic crystal nanobeam with surface effects

Actively Controllable Flexural Wave Band Gaps in Beam-Type Acoustic Metamaterials with Shunted Piezoelectric Patches

Tunable Bandgaps in Soft Phononic Plates with Spring-Mass-like Resonators

Active tuning of flexural wave in periodic steel-concrete composite beam with shunted cement-based piezoelectric patches

Mechanically tunable band gaps in compressible soft phononic laminated composites with finite deformation

Flexural vibration band gaps in a phononic crystal beam containing rotational resonators

Flexural Vibration Bandgaps in Local Resonance Beam with A Novel Two-Degree-Of-Freedom Local Resonance System

Tunable Band Gaps In A Compressible Dielectric Elastomer Thin Cylinder With Periodically Applied Voltages

Multiflexoelectric Actuation and Control of Beams

Tuning the locally resonant phononic band structures of two-dimensional periodic electroactive composites

Low-frequency Band Gaps Within a Local Resonance Structures

Vibration Reduction in a Periodic Truss Beam Carrying Locally Resonant Oscillators

Closed-form bandgap design formulas for beam-type metastructures

Wave Motion in Periodic Flexural Beams and Characterization of the Transition Between Bragg Scattering and Local Resonance

Low Frequency Band Gaps and Vibration Reduction Properties of A Multi-Frequency Locally Resonant Phononic Plate

Retracted: Flexural Wave Suppression By An Elastic Metamaterial Beam With Zero Bending Stiffness (Retracted Article. See Vol. 125, 2019)