Abstract:The effects of inlet drying temperature, initial solute content, hydrolysis time of the precursor, and the choice of solvent were analysed in the synthesis of large (similar to 50 mu m) and uniform SBA-15 microspheres via spray drying. Higher temperatures led to microspheres with larger particles sizes due to a faster evaporation rate. Meanwhile, particle size was proportional to the solute content, thus SBA-15 microspheres with tuneable particle size over a wide range were obtained. Highly ordered mesostructures were assembled for SBA-15 microspheres obtained from initial solute contents between 5 and 12 wt%. Solute contents of lower than 5 wt% or higher than 12 wt% lead to less ordered mesostructures. Increasing hydrolysis time of the precursor solution from 1 hour to 2 hours allowed more cross-linking of silica, thus increasing surface tension forces and resulting in hollow, "bowl-like" particles. Notably, highly oriented mesopores were developed in the "bowl-like" particles. The use of water instead of ethanol as a solvent resulted in disordered "worm-like" mesostructure, with "bowl-like" particles due to the slower evaporation rate. The unique set up of our spray dryer enabled the collection of particles immediately after spray drying. Analyses via SAXS and TEM indicated that the mesostructures were still mobile immediately after spray drying, confirming the so-called "wet-pocket" phenomenon that determined the final mesostructures.

Preparation of Polyacrylate Hollow Microspheres Via Facile Spray Drying

Scalable preparation of hollow polymer and carbon microspheres by spray drying and their application in low-density syntactic foam

Role of Hydrophobic Attraction and Hydrophobic Nanoconfined Channels in the Spray Drying Process for Synthesizing Hollow Microspheres from Silica Sol

Preparation of Hollow Polyurethane Microspheres with Tunable Surface Structures Via Electrospraying Technology

Formation of Uniform Large Sba-15 Microspheres Via Spray Drying

Preparation of Porous and Hollow Microspheres by Suspension Polymerization

Advances in Preparation of Polyacrylamide Microspheres

Effects of the Electrospray Ionization Parameters on the Formation and Morphology of Colloidal Microspheres of Polyacrylonitrile

Effect of Process Parameters on the Performance of Spray Dried Hydroxyapatite Microspheres

Evaporation-inducedself-assembly of Uniform Silica Microparticles with Mesoscopic Structures Via Spray Drying

Porous Al2O3 Microspheres Prepared by a Novel Ice-Templated Spray Drying Technique

A Review of Recent Progress in Preparation of Hollow Polymer Microspheres

Preparation and characterization of Cr 2 AlC microspheres prepared by spray-drying granulation

Controllable Morphology and Wettability of Polymer Microspheres Prepared by Nonsolvent Assisted Electrospraying

Synthesis of acrylic resin and methacrylic resin microspheres by suspension polymerization

Hollow and Porous Hydroxyapatite Microspheres Prepared with an O/W Emulsion by Spray Freezing Method.

Facile Spray-Drying Assembly of Uniform Microencapsulates with Tunable Core-Shell Structures and Controlled Release Properties.

Synthesis of Monodisperse Poly(methacrylic Acid) Microspheres by Distillation–precipitation Polymerization

Polymer-Based Hollow Microspheres : Preparation Methods and Applications

Fabrication and Surface Characterization of Electrosprayed Poly(l‐lactide) Microspheres

Preparation of hollow polymer microspheres Ⅲ. effect of enlarging seed particle