Abstract:Micromachining techniques, in combination with low temperature ceramic composite sol-gel processing, have been used to fabricate annular array thickness-mode piezoelectric micro ultrasonic transducers (Tm-pMUTs). The processing techniques of low temperature (710 degrees C) composite sol-gel ceramic (sol + ceramic powder) deposition and wet etching were used to deposit and structure 27-microm thick lead zirconate titanate (PZT) films on silicon substrates to produce annular array Tm-pMUTs. Using these techniques, high quality PZT materials with near bulk permittivity have been obtained. The Tm-pMUT devices were shown to resonate at approximately 60 MHz in air and 50 MHz in water. From resonance measurements k(t) values ranging between 0.2 and 0.47 have been calculated and shown to depend on the level of porosity within the film. Lower values of kt were observed for films with higher levels of porosity, which was attributed to the relative decrease in the effective piezoelectric coefficient epsilon(33) with respect to stiffness and permittivity as a function of increasing porosity. This paper presents the successful micro-fabrication of a Tm-pMUT device and discusses the optimization of the poling conditions and effect of PZT microstructure on the coupling coefficient k(t). Pulse echo measurements in water, showing a -6 dB center frequency of 53 MHz and 47% -6 dB bandwidth, using a target 15 mm away from the transducer, have been included to demonstrate successful operation of the device. Full analysis of these results will be conducted in later publications.

Design And Fabrication Of A Piezoelectric Micromachined Ultrasonic Transducer Array Based On Ceramic Pzt

Development of PZT-based 18 MHz 2D pMUT array with PDMS waveguide

A Ceramic PZT-Based PMUT Array for Endoscopic Photoacoustic Imaging

A Novel Method for Fabricating 2-D Array Piezoelectric Micromachined Ultrasonic Transducers for Medical Imaging

Fabrication Method of 2-Dimensional Piezoelectric Micromachined Ultrasonic Transducer Arrays

Study of a novel PZT thin films based micromachined ultrasonic transducer for distance measurement

Structure Design and Characterization of MEMS Piezoelectric Ultrasonic Transducer

Fabrication of a piezoelectric micromachined ultrasonic transducer (PMUT) with dual heterogeneous piezoelectric thin film stacking

Fabrication and Characterization of Annular Thickness Mode Piezoelectric Micro Ultrasonic Transducers

A high-density and dual-frequency pmut array based on thin ceramic pzt for endoscopic photoacoustic imaging

Design And Fabrication Of Piezoelectric Micromachined Ultrasound Transducer (Pmut) With Partially-Etched Zno Film

A Multi-Frequency Pmut Array Based on Ceramic PZT for Endoscopic Photoacoustic Imaging

Coupled Piezoelectric Micromachined Ultrasonic Transducers Array with High Ultrasonic Emission Performance

Ultrasonic Transducer Array Design For Medical Imaging Based On Mems Technologies

Highly Sensitive Piezoelectric Micromachined Ultrasonic Transducer (pmut) Operated in Air

Design and Fabrication of High-Frequency Piezoelectric Micromachined Ultrasonic Transducer Based on an AlN Thin Film

PZT-Film-Based Piezoelectric Micromachined Ultrasonic Transducer with I-Shaped Composite Diaphragm

Design and Characterization of High-Density Ultrasonic Transducer Array

Development of a High-Density Piezoelectric Micromachined Ultrasonic Transducer Array Based on Patterned Aluminum Nitride Thin Film

Design and Fabrication of High-Performance Piezoelectric Micromachined Ultrasonic Transducers Based on Aluminum Nitride Thin Films

Piezoelectric Micromachined Ultrasonic Transducers for Ultrasound Imaging